







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Heath, TX: What It Costs and How Long It Takes
A tub-to-shower conversion in Heath, TX typically runs $3,500 – $10,000 and takes 5 to 10 working days from demo to final walkthrough, depending on how far the plumbing and waterproofing go. It replaces the tub with a walk-in shower base or a tiled pan, updates the valve and drain, and closes the old surround. Call (888) 426-8078 for a free on-site estimate before anything gets ordered.
How We Run a Tub-to-Shower Conversion, Stage by Stage

Most homeowners expect a conversion to drag on for a month. It usually doesn’t. Here’s the real sequence, so you know what happens on day one versus day six and what we need from you at each step.
- Stage 1: Site check and written scope (day 1, about 60 – 90 minutes). We measure the alcove, photograph the existing drain and valve location, and check what’s behind the surround. On Heath slab-on-grade homes, that means confirming where the drain ties in before anything gets cut. You decide the shower base size and whether you want tile or a solid-surface wall panel.
- Stage 2: Demo and rough-in (days 1 – 2, roughly 8 – 12 hours). We pull the tub, cut back the surround to studs, and inspect the framing for rot and the slab or subfloor for water damage. If the valve is original, it gets replaced now, not later. This is the day surprises surface, and it’s why we write a fixed price only after opening the wall.
- Stage 3: Plumbing, electrical, and inspection (days 2 – 3). New drain and valve get set, the drain height moves to fit the shower pan, and any niche or light gets wired. We pull the permits this job requires and schedule the rough-in inspection before the walls close. Skipping this is the most common reason a tub-to-shower job fails resale.
- Stage 4: Waterproofing and tile (days 3 – 7). A sloped shower pan goes in, followed by a bonded waterproofing membrane. Tile or panel install takes two to three days depending on pattern and size. You’ve already chosen material grade at the estimate, so nothing stalls here.
- Stage 5: Fixtures and walkthrough (days 7 – 10). Glass, showerhead, valve trim, and grab bars go on. We test the drain for flow, check slopes with a level, and walk the job with you. Most conversions finish in a single visit week if the material is on site.
What you decide, and when: base size and wall material before we order, fixture finish before rough-in, and glass style before stage 5. Those three decisions drive the schedule more than anything we do with our hands.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
No two showers come out of the same catalog. Here’s the honest trade-off on each choice that actually shows up on a Heath estimate.
- Acrylic or fiberglass pan vs. a tiled pan. The acrylic pan is faster, lighter, and holds up to standing water without re-sealing. A tiled pan looks custom and lets you match the shower to the rest of the bath, but it costs more and needs a properly built waterproof membrane behind it. If you’re laying tile anyway, the tiled pan is the better long horizon. If you’re keeping the rest of the bath simple, the acrylic pan wins on cost.
- Tile walls vs. solid-surface panels. Tile gives you a custom look and lets you use real stone or porcelain. Panels are faster to install, easier to clean, and are a strong fit for a smaller bath where the grout budget is better spent elsewhere.
- Frameless glass vs. a framed or no-door setup. Frameless glass opens the bath up and suits a lake-view home where the bathroom is small but the view is the point. A sliding or fixed glass panel costs less and works with narrower door openings.
- Valve and showerhead grade. A builder-grade valve is what usually fails on a 1970s – 1990s Heath ranch home. Upgrading to a pressure-balance valve during rough-in is cheap insurance against a rebuild later.
We only use brand partners we’ve vetted, including Therma-Tru and Mr-Glass for glass enclosures, so you’re picking between quality, not just availability. Our Bathroom Remodeling team can pull those selections together before install day.
What Tub-to-Shower Conversion Costs in Heath, TX

For a single alcove, a full tub-to-shower conversion runs $3,500 – $10,000 in Heath, with the typical custom tile job landing around $6,000 – $8,000. If you’re converting a larger area or adding a second shower, the number can climb higher, and if you’re doing this as part of a full Bathroom Remodeling in Heath, it gets rolled into that scope.
Here’s what pushes a job to the low or high end:
- Size. A standard 60-inch alcove sits at the low end. Extending the footprint or going curbless moves you up.
- Existing condition. If the old tub was leaking or the surround needs framing repairs, that adds cost.
- Moving plumbing or the drain. Leaving the valve and drain in place saves money. Relocating them for a better layout is where the price steps up.
- Material grade. Acrylic pan and panels are the low end. Full tile, natural stone, and frameless glass are the high end.
- Permit scope. A tub-for-shower swap usually needs a permit in Heath, and the inspection is part of the number.
What’s included: demo, waterproofing, tile or panel install, new valve, drain, fixtures, glass, permits, and cleanup. What typically isn’t: structural repairs discovered after demo, and anything beyond a standard-size shower base. Your estimate spells out both, in writing, so you don’t get a surprise invoice.
See the difference
Before
After
Before
After
Before
AfterWhat Heath Homes Specifically Do to This Job
Heath is a fast-growing, upscale lakefront suburb on the east shore of Lake Ray Hubbard, and that shapes the conversion job. Homes on the lake side are often custom and semi-custom builds on large, heavily wooded lots, where elaborate roof lines and multi-level layouts mean the bathroom is bigger (and further from the main water line) than a typical suburban bath. Because many of these homes sit on floodplain-adjacent or lake-view parcels, we’re often checking drainage and moisture around the bath before we open the walls.
The older ranch homes from the 1970s – 1990s along the lake are where we see the real failure patterns: expanding clay soils that shift the slab, older cast-iron or galvanized drain lines, and original valves that make it past 40 years before giving up. If a tub was set on a shifted slab, the new shower pan has to correct for it, not fight it. On the custom side, tight setbacks and tree-preservation rules mean extra coordination on any exterior work, but inside the bath the job stays simple. We serve the 75032 side of Heath and the surrounding area, and homeowners often pair this conversion with Metal Roofing in Heath or Tile Roofing in Heath while we’re on site.
Serving Heath, TX – Our Local Coverage Area
We serve Heath and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Tub-to-Shower Conversion in Heath

Most conversions take 5 to 10 working days, with tile jobs running longer than acrylic panel jobs. Add a few days if the drain or valve needs relocating. We give you a written schedule with the estimate so you know the start and finish dates.
Usually yes, because the drain and valve are plumbing work and Heath requires an inspection on those changes. We pull the permit and pass the inspection as part of the job. Call (888) 426-8078 and we’ll tell you exactly what your address needs.
Yes, and it’s the most common path. Keeping the valve and drain in the same spot saves cost and days. If the layout needs to shift, we quote that separately before demo.
Expect the upper end of the $3,500 – $10,000 range if there’s framing or subfloor damage under the old tub. We open the wall first, photograph what we find, and quote the repair in writing before we start it. No hidden add-ons. Call (888) 426-8078 for an exact number.
Every conversion is backed by our 730-Day Done Right Promise: if the workmanship fails, we come back and fix it. That covers the install and waterproofing, not the fixtures or glass, which carry their own manufacturer warranties. Estimates are free, so call (888) 426-8078 to schedule one.
Schedule Your Free Tub-to-Shower Conversion Estimate in Heath
Call (888) 426-8078 and we’ll book a free on-site estimate at your Heath home. We measure the alcove, check the drain and valve, and hand you a written line-item price with the schedule and the permit scope in it. You’ll know the exact number before anything gets ordered, and the work is covered by our 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co.












