







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Rockwall, TX: What It Costs and What the Job Really Involves
Door installation in Rockwall, TX usually runs $650 to $2,900 per door for a standard single exterior or interior door, with most single-door projects finished in one day and multi-door jobs stretching across two or three. Entry systems with sidelights and custom sizes climb higher. On the lake side, near-shore and pier-and-beam homes add a wrinkle most bids skip. Call (888) 426-8078 for a free on-site estimate and you’ll get a line-item quote in writing.
How We Run a Door Installation, Start to Finish

Every door install follows the same five stages. What changes is the condition of the existing opening, and that’s where the schedule lives or dies.
- Stage 1 – Measure and site review (day 1, 45-90 minutes). We pull the trim back, check the rough opening for square and plumb, and test the sill for rot. On pier-and-beam homes up the slope above Lake Ray Hubbard, we also check for racking – a floor that’s shifted out of level because of clay-soil movement. If the opening is out of square by more than about a quarter inch, the install plan changes before anyone swings a hammer. You decide the door model, finish, and swing direction here.
- Stage 2 – Demo and prep (2-4 hours). The old door, trim, and threshold come out. Rot in the sill or jack stud gets cut back and replaced with treated lumber. On the 1990s brick-and-stone builds in Stone Creek and Chandler’s Landing, we’re usually pulling a builder-grade steel door still hanging on its original hinges – the frame is often the first thing to go. No door goes in over soft wood.
- Stage 3 – Set and shim (1-2 hours). The new door goes into the opening, shimmed at the hinges and latch side, checked for reveal consistency, then fastened with structural screws. Exterior doors get flashed and sealed at the threshold and jamb before the trim goes back on. Interior doors get checked for swing and latch alignment against the strike.
- Stage 4 – Hardware and finish (1-2 hours). Hinges, lockset, deadbolt, weatherstripping, threshold, casing, and paint or stain on the trim. On exterior doors you decide the hardware finish and whether the deadbolt is keyed to match the rest of the house. This is also where the closer on a storm door or a sliding screen gets dialed in.
- Stage 5 – Inspection and walkthrough (30-45 minutes). We check the seal against light and water, test the latch, confirm nothing rubs, and walk the job with you. If a permit was pulled for the structural portion (a widened or new opening), the city inspection happens here. You sign off only when you’re satisfied.
Most single-door jobs run four to six hours on site. A full exterior entry system with two sidelights is typically a two-day job. Interior door swaps in a set of three can finish in one long day if the openings are true.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Door installation is mostly a decision problem, not a labor problem. Here’s what to weigh before you commit:
- Material – steel, fiberglass, or wood. Steel exterior doors are the least expensive, run $350-$900 for the slab, and resist dents but can rust at seams if the finish fails. Fiberglass costs more ($600-$1,500 slab) and holds up better to North Texas heat and the lake moisture moving through the air. Wood is the premium pick ($1,200-$3,000+ slab) and looks the best on the older lake cottages in 75032, but it wants annual attention. For a home near the water, we usually steer toward fiberglass.
- Pre-hung vs. slab. A pre-hung door comes already mounted in its frame – faster to install, cleaner result when the existing frame is sound or needs replacing. A slab-only door costs less but requires reusing the existing frame, which only works if that frame is straight and solid.
- Interior material – hollow-core vs. solid-core. Hollow-core interior doors run $150-$400 installed and are fine for closets and secondary rooms. Solid-core ($250-$600) cut sound transfer and feel substantial on bedroom and bathroom doors.
- Hardware and finish. Entry hardware is where the brands most homeowners recognize show up – Moen and Kohler both make quality lever and deadbolt sets ($80-$300 per set). Finish choice matters more than you’d think near the lake; satin nickel and oil-rubbed bronze hold up better than polished chrome against humidity.
- Energy and security extras. Insulated core, weatherstripping grade, multi-point locking, and impact-rated glazing each push the number. Worth it on an entry door facing the exposed west sun off the water.
What Door Installation Costs in Rockwall, TX

Door installation in Rockwall, TX runs $650-$2,900 per door for most single exterior and interior doors, all-in. Here’s a tighter read on where a job lands:
- Single interior door (hollow-core or solid): $250-$700 installed.
- Single exterior entry door (steel or fiberglass slab, pre-hung, hardware): $900-$2,400 installed.
- Entry system with sidelights or a double-door front: $2,200-$5,500 installed.
- Full set of interior doors on a typical 3-bedroom home (8-10 doors): $2,000-$5,800.
- Structural opening (widening or moving a wall opening): add $800-$2,500 in framing, drywall, and finish work.
Four things push a Rockwall door install to the low or high end. Size and material grade are the obvious ones. Existing condition is the sleeper – rot in the sill or framing can double the labor. Whether the opening is structural (moving a wall) versus a direct swap is the biggest single variable. And permit scope: a direct door replacement usually doesn’t require a permit, but a new or widened opening does. Every estimate we write is line-item – you see materials, labor, trim, hardware, and permit fees separately. No-hassle upfront pricing – the number you see is the number you pay. 0% financing for 18 months is available, and projects over $10,000 get $1,000 off.
See the difference
Before
After
Before
After
Before
AfterWhat Rockwall Homes Specifically Do to a Door Install
Rockwall sits on the east bank of Lake Ray Hubbard, and the homes here split into two very different installation problems. The 1990s-2000s brick-and-stone subdivisions like Stone Creek and Chandler’s Landing (mostly 75087) have doors that are 25-35 years old now and showing it – sagging hinges, failed weatherstripping, and thresholds that have taken on water every spring. That’s a fairly straightforward swap once the frame is checked. The older pier-and-beam lake cottages on the original shore streets of 75032 are the harder job. Those homes shift on Blackland Prairie clay that swells and shrinks with every wet-dry cycle, and a doorway that was square five years ago often isn’t now. We see binding latches and gaps at the top corner of the jamb on those homes regularly. On the lake side, humidity moving off the water speeds up corrosion on steel frames and rust on hinge screws. If a door opening is within sight of the water or on a pier-and-beam foundation, we check the rough opening against a level before we trust the old measurements. For waterfront projects that touch the shoreline, Corps of Engineers and City of Rockwall dock rules can come into play – rare for a door swap, but worth knowing if the project grows into a deck or boathouse rebuild. We cover Rockwall and nearby Heath, Fate, Royse City, and Rowlett.
Serving Rockwall, TX – Our Local Coverage Area
We serve Rockwall and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Rockwall

A single door install takes four to six hours on site, and most jobs finish in one day. Multi-door sets run two to three days. Structural openings add time for framing, drywall, and inspection. Call (888) 426-8078 for an exact schedule based on your home.
A direct replacement in an existing opening usually does not require a permit, but a new, widened, or relocated opening does. We pull the permits and pass the inspections when they’re required – that’s included in the written estimate. Call (888) 426-8078 and we’ll tell you upfront whether your job needs one.
Yes, in the vast majority of cases. A direct swap reuses the existing opening and framing and doesn’t touch plumbing or structure. Only a widened opening or a moved doorway crosses into structural work, and we’ll flag that before any contract is signed.
Most single doors run $650-$2,900 installed, with interior doors at the low end and exterior entry systems at the high end. Structural openings add $800-$2,500. Call (888) 426-8078 for a free line-item estimate – no surprises once work starts.
Every door we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s labor and workmanship, backed in writing. Manufacturer warranties on the door itself pass through to you. Call (888) 426-8078 with any warranty question.
Homeowners often pair door replacement with a wider exterior refresh, and it fits naturally alongside our Windows & Doors in Rockwall work or a fence upgrade. If the back yard is getting attention too, Chain Link Fence in Rockwall and Vinyl Fence in Rockwall installs are common add-ons. For the full scope, see our Windows & Doors service.
Get a Free Door Installation Estimate in Rockwall
Call (888) 426-8078 for a free on-site estimate on door installation in Rockwall. We’ll measure the opening, check the frame and sill, and hand you a written line-item quote – materials, labor, hardware, trim, and any permit fees, all separate. The number you see is the number you pay. 0% financing for 18 months is available, and projects over $10,000 get $1,000 off. Live person answers the phone 24/7, no voicemail.
Written by the team at Groundwork Construction Co.












