







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Balch Springs, TX: Cost, Timeline, and What’s Actually Involved
A chain link fence in Balch Springs runs $3,500 to $9,000 for a typical residential lot, and most jobs are finished in one to three days once materials are on site. That range covers a standard 4-foot or 6-foot galvanized run with posts set in concrete, terminal posts on every corner and gate, and tension wire along the bottom. Longer property lines, corner lots, and gates push toward the top of the range. Call (888) 426-8078 for a free on-site estimate.
How We Build a Chain Link Fence, Stage by Stage

The sequence matters more than the product. Here’s exactly what happens, roughly in order, and what you decide at each point.
Stage 1: On-site measure and layout (day 1, 45 to 90 minutes)
We walk the property line with you and mark every corner, every gate, and every terminal post. You decide two things right here: where the gates go and which side the fabric faces. On a lot with a shared fence line, we also confirm who owns which stretch, since a fence built two inches onto the neighbor’s side becomes their problem to fight over later. Your written estimate comes out of this visit with line items, not a lump number.
Stage 2: Utility locate and permit check (day 1 to day 5)
Texas law requires the 811 call before anyone digs, and we make it. That mark-out takes a few business days and is the single most common reason a fence job slips a week. On the permit side, most residential replacement runs in Balch Springs fall under the city’s standard fence and accessory-structure review, and any run near a right-of-way or easement gets checked against the plat before we dig a single hole. We pull what’s required and hand you the inspection paperwork.
Stage 3: Demolition and post holes (day 1 or day 2, 3 to 6 hours)
Old fence comes out, concrete footings get busted down and hauled off, and new holes go down 24 to 36 inches depending on frost line (not a real factor here) and wind load. That’s the honest driver in North Texas: wind. Posts on a 6-foot run go closer together than the old fence probably had them, and every corner and gate post gets a heavier gauge and a larger concrete collar. You’ll see the difference in a straight-line wind, and you’ll feel it when you grab the top rail.
Stage 4: Setting posts and stretching fabric (day 2 or day 3, 4 to 8 hours)
Concrete cures, posts get checked for plumb, and the fabric goes up under tension with a come-along rather than by hand. This is where cheap jobs show themselves: sagging fabric, wavy top rail, gaps at the bottom. We set terminal posts, add tension bars at every end and corner, and run a bottom tension wire so a dog can’t push out underneath. Gates get hung and swing-checked before we leave.
Stage 5: Final walkthrough and cleanup (same day, 30 minutes)
We walk the run with you, show you every gate latch, and haul off all old material and concrete debris. Any adjustment you want gets made on the spot. All of it is backed by our 730-Day Done Right Promise: if a post leans or a gate sags in the first two years, we come back and make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Actually Choose Between
Chain link is not one product. The choices below are the ones that move both the price and the useful life of the fence.
- Galvanized vs. vinyl-coated fabric. Standard galvanized is the budget leader and holds up fine in North Texas humidity, though it dulls to gray over time. Vinyl-coated (black or green most commonly) costs roughly 15 to 25 percent more and reads much less like a chain link fence from the street, which matters on a corner lot or a property next to a nicer subdivision. It also resists the rust bloom that shows up on cheap galvanized after a decade.
- Gauge of wire. 11.5-gauge is the residential standard; 9-gauge is heavier and worth it on a run that takes abuse from dogs, balls, or a gate that gets slammed. Ask what gauge you’re being quoted. It’s the easiest place for a low bid to hide.
- Height. 4-foot is the common front-yard or side-yard height. 6-foot is the standard for a backyard. 8-foot shows up on commercial and on properties with a pool. Taller means more wind load and heavier posts, which is why going from 6 to 8 feet is not a simple line-item bump.
- Post and rail schedule. Line posts every 8 to 10 feet, terminal posts on every corner, end, and gate, and a top rail through the whole run. Skipping terminal posts on short runs is the single most common shortcut we correct on repair calls.
- Gates and hardware. A walk gate with a self-closing hinge and a drop rod is the everyday choice. A double drive gate for vehicle access needs heavier posts set deeper, usually with a full concrete collar. Every gate is the weak point of any fence, so the hardware is where we don’t cut corners.
- Privacy slats and top rail style. Snap-in slats add privacy and a bit of wind catch; they’re a reasonable add-on when you want chain link’s durability with a little more screening. Slats roughly add 10 to 20 percent to a run’s cost and need occasional replacement after heavy weather.
What a Chain Link Fence Costs in Balch Springs, TX

Expect $3,500 to $9,000 for a residential chain link fence in Balch Springs, depending on length, height, gate count, and how much old fence has to come out. Here’s how the line items typically break down.
| Line item | Typical range |
|---|---|
| Standard 6-foot galvanized run (150 to 200 linear feet) | $3,500 – $6,500 |
| Vinyl-coated upgrade | adds 15% – 25% |
| Walk gate (installed, with hardware) | $250 – $550 each |
| Double drive gate | $600 – $1,400 |
| Old fence removal and haul-off | $400 – $1,200 |
| Privacy slats | adds 10% – 20% |
| Concrete footings and terminal posts | included in standard quote |
Four things push a job toward the high end: total linear footage, height above 6 feet, number and size of gates, and site conditions like rocky dig zones or a run that crosses a concrete pad. Permit fees and any survey work sit on top, and we show those separately so you know what’s a government cost and what’s ours.
What’s included in every written quote: posts, concrete, fabric, top rail, tension wire, terminal posts, gate hardware, cleanup, and haul-off. Upfront pricing, no surprises: the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Balch Springs Homes Specifically Do to a Chain Link Fence
Balch Springs sits in the heart of the Texas blackland prairie, where expansive clay soils shrink and swell with every wet-dry cycle in ZIP 75180 and the surrounding blocks. That geology is the whole story for a fence here. After a heavy spring rain, the clay under a post hole swells, then dries and shrinks through a July, and a footing that was dead plumb in March can lean three or four degrees off by fall. We see it in older neighborhoods where the fences were set in skinny hand-dug holes with too little concrete. It also shows up on the housing stock itself: many homes here are pier-and-beam or shallow slab, and a fence run that ties into a settling structure pulls loose at the first post.
The fix is straightforward but it costs a little more up front. We over-bore the footing, bell the bottom of the hole, and use more concrete than a minimum-code job. The wire gauge and post schedule get sized for wind, not just length. And because the area’s humid summers and heavy rains accelerate rot on anything wooden and rust on anything cheap, we spec galvanized or vinyl-coated fabric and hardware that won’t rust out in five years. If a fence is part of a broader yard redo, a lot of Balch Springs homeowners pair this with Concrete Driveways & Concrete Work in Balch Springs while the site is already torn up, and some go further and roll it into a full Fence Installation in Balch Springs project that covers the entire property line. We cover every block in Balch Springs, and the same soil is under our feet on every job we run in Mesquite and Garland next door.
Serving Balch Springs, TX – Our Local Coverage Area
We serve Balch Springs and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Balch Springs

A typical residential run goes in over one to three days once materials arrive. The scheduling drag is the 811 utility locate, which takes a few business days; that usually determines your actual start date more than build time does.
Most residential fence work in Balch Springs goes through the city’s standard fence and accessory-structure review, and any run near a right-of-way or easement gets a closer look. We handle the permit pull and the inspection so you don’t sit on hold at the city offices. Call (888) 426-8078 and we’ll tell you exactly what your lot needs.
Yes, in almost every case. Fence posts go in along the property line, well clear of the footing and the plumbing runs inside the slab. The utility locate is the safety net; if a line runs where we planned to dig, we shift the post rather than risk it.
A standard residential run comes in between $3,500 and $9,000, depending on length, height, gate count, and old-fence removal. The high end is usually a longer property line, 8-foot sections, or a driveway gate.
Every chain link fence we build is covered by our 730-Day Done Right Promise – if a post leans or a gate sags during that window, we come back and fix it. That’s backed by background-checked, uniformed technicians on every job and one point of contact for the whole run.
Get a Free Chain Link Fence Estimate in Balch Springs
Call (888) 426-8078 for a free on-site estimate on a chain link fence in Balch Springs. A live person answers around the clock, and the visit takes under an hour: we walk the line with you, mark the gates, confirm the permit picture, and hand you a written line-item quote. No pressure, no surprise add-ons, and 0% financing for 18 months if you need it. Fence Installation is what we do every week – let’s put a number on yours.
Written by the team at Groundwork Construction Co.












