







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Iron Fence in Lucas, TX: What It Costs and How Long It Takes
An iron fence on a Lucas acreage property typically runs $3,500 to $9,000, depending on linear footage, style, and how much site work the run requires. Most residential jobs here are measured, set, and finished in three to six working days once materials land on site. Call (888) 426-8078 for a free on-site estimate and we’ll walk the property line with you before any number is written down.
How We Build an Iron Fence on a Lucas Property

Every job here starts with a walk of the actual line, not a measurement off a plat map. On acreage, fence lines wander, and the setback from a shop or barn rarely matches what the county drawing shows. We settle the run first, then the rest follows.
Day 1: Layout and utility locate
We stake the line and confirm setbacks against your survey. Then the 811 locate gets called and we wait for flags before a shovel touches ground. This is the stage where most rural jobs reveal surprises: an old septic lateral, a buried water line to a barn, or a driveway culvert that forces a panel shift. You decide the exact corner points with us on the ground before we cut anything.
Day 2: Demo and post setting
Old fencing comes out and posts go in. On Lucas clay, that means concrete-set posts and deeper footing on gate posts, because Blackland soil moves through the wet and dry cycle. Post holes on a long run can eat most of a day. You’ll want to decide gate placement and swing direction now, because changing it later means re-pouring.
Day 3: Rails, pickets, and alignment
Top and bottom rails go on, then pickets get set and leveled. This is the part that shows. Iron reveals every high post and every dip in grade, so the leveling is slow work. If the line crosses a slope, we step the panels rather than rack them, and that’s a decision you should be part of.
Day 4 to 5: Gates, hardware, and finish
Gate frames get hung and checked for clearance, latches and stops installed, and any welded or powder-coated touch-up completed. A double-drive gate takes longer than a walk gate. We test the swing in front of you before we call it done.
Final walk and warranty handoff
We walk the whole run together, check post plumb, gate operation, and finish, and hand you the 730-Day Done Right Promise in writing. If something isn’t right, we make it right. That’s the whole point of a written guarantee.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Iron Fence Options You’ll Choose Between
Most buyers here are picking between a few real categories, and each one has a trade-off worth knowing before you sign.
- Wrought iron (solid bar): The heaviest and longest-lived option. It handles a long rural run well but costs the most and needs periodic paint or a quality powder coat to keep rust off.
- Steel with powder coat: Close in look to wrought iron at a lower number. The finish matters more than the metal here, so spec a reputable coater and expect it to outlast a cheap finish by years.
- Aluminum ornamental: Lighter, won’t rust, and easier on gate hardware over time. It won’t take the same abuse as steel around a shop or equipment yard, so it suits a front boundary better than a working area.
- Height and spacing: A 4-foot run reads as decorative; 5 to 6 feet reads as a real boundary. Tighter picket spacing costs more per foot but closes gaps a dog or goat can slip through, which matters on acreage.
- Gate configuration: A single walk gate vs a double drive gate changes the hardware and the footing. Wide vehicle gates need heavier posts and often a different latch system.
If the iron fence is part of a full Fence Installation in Lucas plan that also includes a rear boundary or a pasture run, we’ll price the whole thing together so the specs match.
What Iron Fence Costs in Lucas, TX

Expect $3,500 to $9,000 for a typical residential iron fence here. That’s a real range, not a placeholder, and the spread comes down to five things.
- Linear footage: The single biggest driver. A short front boundary sits near the low end; a full perimeter on a multi-acre tract pushes toward the high end.
- Existing condition: Removing old fencing, clearing brush, or cutting through a grown-over line adds labor before a single post goes in.
- Grade and soil: Sloped or uneven Blackland ground means more footing work and stepped panels.
- Material grade and finish: Solid bar and premium powder coat cost more up front and hold up longer.
- Gate count and width: Each gate is its own hardware and footing job, and wide drive gates cost meaningfully more than walk gates.
Your written estimate should show the run, post spacing, material spec, gate count, and finish line by line. What it shouldn’t hide is utility locate timing, demo of an old fence, or disposal, and those are the line items that quietly balloon a bid elsewhere. Our pricing is upfront, no surprises, and the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Lucas Homes Specifically Do to This Job
Lucas is a semi-rural Collin County town where the work is dominated by large-lot custom homes and acreage properties on Blackland Prairie ground north of Wylie and Allen. That changes an iron fence job in ways a suburban installation never sees. Runs are longer, lines cross working ground, and the property often includes a detached shop, barn, or oversized garage door that a fence has to route around rather than through. We coordinate around septic and well equipment as a matter of course, because on these tracts that’s the norm, not the exception.
The heavy clay under most Lucas acreage is the other factor. It shrinks and swells through the wet and dry cycle, so foundation and slab work here needs to be engineered for movement, a failure mode far less pronounced on the sandier ground closer to central Collin County. For iron fence, that means post footings sized for that movement and gate posts that won’t heave and bind after a wet spring. Hot summers and spring hail and wind storms also test finishes and hardware, which is why we spec coatings that hold up rather than the cheapest option on the shelf. We cover Lucas and the surrounding area with the same approach to site conditions. Homeowners often pair an iron boundary with Patios, Walkways & Pool Decks in Lucas when the exterior project runs together.
Serving Lucas, TX – Our Local Coverage Area
We serve Lucas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Iron Fence in Lucas

Most residential runs are finished in three to six working days once materials are on site and utilities are located. Long perimeter runs on acreage or jobs with multiple gates push toward the longer end, and utility locate timing can add a day. Call (888) 426-8078 for a realistic schedule on your specific line.
It depends on height, location, and whether the run is in a setback or floodplain area, so it’s worth confirming before work starts. We’ll walk you through what applies to your property during the estimate and pull what’s required. Call us and we’ll sort out the permit question before anyone digs.
Yes, in nearly every case, as long as we locate the lines first. On acreage properties we call the 811 locate and adjust the run before post holes are set. If a line can’t be moved, we plan the panel around it. Call (888) 426-8078 and we’ll talk through your site.
No. Our pricing is upfront and the number on the written estimate is the number you pay. Changes only come from work you ask to add, and those get quoted in writing before we do them. Call for a written line-item estimate with no surprises.
Every project is covered by the 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If it isn’t done right, we make it right. Financing is available at 0% for 18 months, and there’s $1,000 off projects over $10,000.
Get a Free Iron Fence Estimate in Lucas
If you’re weighing an iron fence for a Lucas property, start with a free on-site estimate. We’ll walk the line with you, confirm setbacks and utility locations, and put the specs and the price in writing before any work starts. Call (888) 426-8078 and a live person will set up the visit, whether it’s midday or a weekend evening. Our technicians have up to 12 years of experience and arrive background-checked and in uniform.
Written by the team at Groundwork Construction Co.












