







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterTub to Shower Conversion Cost in Mesquite, TX: Real Numbers for Older Ranch Homes
Tub to shower conversion in Mesquite runs $3,500-$10,000 for a standard footprint, and that range covers the work most contractors quote. Prefab drop-in units land near the low end; a custom tiled walk-in shower with a frameless glass door and a proper waterproofing system sits at the high end. Custom builds that require drain relocation, framing repair, or moisture remediation push toward $14,000. We fix the number in writing after the pre-demo scope walk, and you can get that scheduled today by calling (888) 426-8078.
Pull the tile off a 1965 Mesquite tub surround and there’s about a 60% chance the studs behind it are soft. That’s not a scare tactic. It’s a framing reality that changes your conversion budget, and it’s the single cost variable most online guides skip.
Key Takeaways
- Most Mesquite ranches were tiled over greenboard or drywall with no true waterproof membrane. Expect moisture damage behind the surround.
- Prefab conversion: roughly $3,500-$10,000. Custom tile with frameless glass and a membrane system: $7,000-$14,000.
- Drain relocation on a slab adds $700-$1,400. It’s often required when a 60″x30″ tub footprint becomes a walk-in.
- Every conversion we complete carries the 730-Day Done Right Promise – waterproofing, tile, and door seal covered for two full Texas wet seasons.

Why Mesquite’s Aging Tub Alcoves Change the Price
Mesquite is a built-out inner-ring Dallas suburb. Most of the housing stock went up between the 1950s and 1970s, and the work here is overwhelmingly renovation and replacement rather than new construction. That matters for a bathroom project because the tile you see was installed under a different set of habits than today’s.
In those decades, a common tub surround was tile set directly over greenboard or plain drywall. No cement board. No liquid-applied membrane. No Schluter system. The tile itself was expected to keep the water out, and for a while it did. Fifty-plus years of steam, splash, and slow wicking later, the substrate behind it has taken on moisture. When we demo a surround, we frequently find soft framing, rusted fasteners, and a stud wall that needs sistering before a new shower can be hung on it. We price that as a likely line item, not an optional contingency you’ll be surprised by mid-job.
The clay soil under Mesquite compounds this. The black clay swells and shrinks with wet-dry cycles, and that movement shows up in older bathroom floors as cracked tile and hairline slab shifts. When we set a new shower pan, we check the floor for level and movement before we commit to a drain height. Skipping that step is how a shower starts pooling water on one side within a year.
What to Look For in a Mesquite Tub-to-Shower Bid
Most quotes you’ll collect will look similar on paper. The differences show up in what they don’t say. Here’s what separates a bid that holds up from one that grows after demo.
- Waterproofing named explicitly. A serious bid specifies the membrane system: cement board plus liquid membrane, or a bonded sheet system. “Tile over backer board” without a membrane is a five-year shower.
- Demo and remediation scoped separately. Ask what happens if the studs are soft. A contractor who won’t put a remediation number in writing is telling you they’ll find it later and bill you then.
- Drain position confirmed. A 60″x30″ tub drain rarely lines up with a walk-in layout. The bid should state whether relocation is included or priced.
- Glass and door hardware spelled out. Frameless glass with quality hinges is a real cost. So is a bypass slider. Make sure you know which is in the number.
- Workmanship warranty in plain language. Not a manufacturer warranty on the tile, a warranty on the install. Ours runs 730 days.
We handle the full scope from foundation to finish line, so the demo, plumbing rough-in, waterproofing, tile, glass, and paint all sit under one contract and one promise. If you’d like to see how that fits into a larger project, our Bathroom Remodeling in Mesquite page lays out the full-room version.

What Does a Tub to Shower Conversion Cost in Mesquite?
Here’s where the money actually goes for a Mesquite conversion, line by line. These are the ranges we work from, calibrated to this market:
| Line Item | Price Range |
|---|---|
| Prefab tub-to-shower conversion (drop-in unit, standard footprint) | $3,500-$10,000 |
| Custom tile shower with frameless door and membrane system | $7,000-$14,000 |
| Walk-in shower installation (new footprint) | $4,500-$12,000 |
| Shower replacement (existing shower, no footprint change) | $3,000-$8,500 |
| Drain relocation (slab penetration, Mesquite) | $700-$1,400 |
| Moisture remediation and stud wall repair (when found) | Priced at scope walk |
| Full bathroom remodel (if the project grows) | $9,000-$28,000 |
| Small bathroom remodel | $5,000-$12,000 |
The gap between a prefab conversion and a custom tile build is almost entirely about waterproofing reliability. A prefab unit comes with its own molded pan and wall panels, and the joints are sealed at install. A custom tile shower requires a membrane behind everything, a properly sloped pan, and a door seal that holds. Done right, it lasts decades. Done wrong, it fails quietly and shows up as a soft spot two years later. That’s why every conversion we finish is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right.
Pricing is upfront and fixed after the scope walk. No surprises, no change-order ambushes. And if your project crosses $10,000, you can stack the $1,000 off projects over $10,000 promotion with 0% financing for 18 months. Our technicians have up to 12 years of experience and arrive background-checked and in uniform. If you’re sketching a bigger rework, our Bathroom Remodeling hub covers how the shower fits into a full-room plan.
How Does the Pre-Demo Scope Walk Work?
Before we put a number in the contract, we walk the bathroom and check three things: framing condition behind the surround, drain position relative to the new shower footprint, and floor level. This is where the moisture damage gets found, before it becomes a mid-project surprise.
We probe the wall at the shower valve and the tub deck. We check for tile that sounds hollow. We confirm where the existing drain sits and whether relocation is on the table. And we measure the floor for movement tied to Mesquite’s clay soil. The result is a fixed-price proposal that reflects what’s actually there, not what a phone estimate guessed. Most scope walks take under an hour, and the estimate and design consult are free.
FAQs
Most Mesquite conversions fall between $3,500 and $10,000, with custom tile builds reaching $14,000 when drain relocation and moisture remediation are involved. The low end is a prefab drop-in unit; the high end is a fully waterproofed custom shower with frameless glass. Call (888) 426-8078 for an exact quote after a scope walk, and the estimate is free.
Replace, almost always. When the greenboard behind a 1960s tub surround has gone soft, patching tile over compromised framing kicks the problem down the road a year or two. In our experience, the remediation adds to the front-end number but saves the cost of a full redo later. We’ll show you what we find during the scope walk so you can decide with real information.
In most cases yes, because the conversion involves plumbing changes and often a drain relocation. The permit requirement depends on whether the rough-in is altered, and we handle the paperwork as part of the job. Confirm the specifics with the city before work begins; your contractor should be the one walking you through it.
For a prefab drop-in over a standard footprint with no surprises behind the wall, yes, most of these are finished in a single day. Custom tile work needs a few days for membrane curing, tile setting, and grout, plus glass templating and install. We’ll tell you up front which schedule your project falls into. Call (888) 426-8078 and we’ll get a technician scheduled.
Get Your Fixed-Price Conversion Quote
Mesquite’s older ranch homes deserve a shower built for the long haul, not a patch over failing framing. Groundwork Construction Co. of Mesquite performs the pre-demo scope walk, quotes a fixed price with no surprises, and backs the work with a 730-Day Done Right Promise. Calls are answered by a live person 24/7. Call (888) 426-8078 for your free estimate and design consult.
Written by the team at Groundwork Construction Co. of Mesquite, serving Mesquite, TX.
What Our Customers Say
"We lived in the house through the whole thing. He kept the dust wall up, cleaned every Friday, and made sure we always had a working bathroom."
- Craig Whitaker"Found unpermitted work by the previous owner once he opened the wall. He stopped, explained the options and what each would cost, and let me decide rather than making it my emergency."
- Marco Castillo"He told me one part of what I wanted was a bad idea structurally and offered an alternative instead of just taking the money."
- Angela Wong












