







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Mesquite, TX: What It Costs and How Long It Takes
A tub-to-shower conversion in Mesquite typically runs $3,500 to $10,000 and takes 5 to 10 working days once permits clear. The job removes the old tub, reframes and waterproofs the opening, sets a new shower pan and drain, tiles the walls and floor, and reinstalls fixtures and valve trim. Most Mesquite homes we open up were built between 1955 and 1978, so what’s behind the tub wall usually sets the schedule. Call (888) 426-8078 to schedule a free on-site estimate.
How the Conversion Actually Goes, Stage by Stage

Every conversion has five real stages. Here’s what each one involves and what you decide while it’s happening.
Stage 1: Site visit and written scope (day 0, about 90 minutes)
We measure the alcove, check the valve wall, and look at how the tub drain ties into the stack. You get a line-item written estimate with material allowances spelled out, not a lump sum. This is where you pick shower pan type, tile grade, and whether the valve moves. Numbers are locked before demo starts.
Stage 2: Permit and demo (days 1 – 2)
Plumbing and electrical changes generally require a Mesquite permit, and inspections are tied to that permit. Demo removes the tub, surround, and old valve trim. We protect the vanity and flooring and haul everything out. Expect noise and dust on these two days; plan to be out of the house or at least off the second floor while it runs.
Stage 3: Rough-in and framing (days 3 – 4)
New drain and valve get set and the wall gets reframed for the shower footprint. If your 1960s cast iron drain is cracked or the valve wall has old galvanized supply lines, this is where the budget moves, and we tell you before we touch it. Rough plumbing inspection happens here.
Stage 4: Waterproofing and tile (days 5 – 8)
A proper pan is set with a pre-slope, liner or a bonded waterproof membrane, then walls get cement backer or foam board. Tile goes up over two or three days depending on size. You’ll approve layout and grout color before setting; changing grout after it’s on the wall means starting over.
Stage 5: Fixtures, glass, and final inspection (days 9 – 10)
Shower head, valve trim, drain grate, and glass go in. Final plumbing inspection runs, then we clean up and walk you through it. The 730-Day Done Right Promise covers the workmanship from that walkthrough forward.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Most of the decision pressure lands on four things. Here’s the honest trade-off on each.
- Shower pan: Acrylic pans are the fastest and cheapest, around $350 to $700 installed, and hold up well but look like a pan. Tiled pans with a membrane run $1,200 to $2,500 and look better but depend entirely on the installer’s waterproofing.
- Wall material: Tile over cement board is standard and lasts decades. Acrylic surrounds cost less and install in a day but can yellow and crack at 15 to 20 years. Foam board systems (Schluter, Wedi) are lighter and better in older walls that aren’t flat.
- Valve and trim: Keeping the existing valve saves $400 to $900. Replacing it with a new pressure-balance valve is smart on a 50-year-old wall and required in some cases by current code for anti-scald. Kohler and Moen are the two we install most.
- Glass: Framed sliding doors cost $600 to $1,100 and work in tight alcoves. Frameless panels look cleaner but need solid blocking and add $900 to $1,800.
Tile size matters more than people expect. Large-format 12×24 tile runs faster and cheaper on labor than small mosaic, which adds $800 to $1,500 in setting time.
What Tub-to-Shower Conversion Costs in Mesquite, TX

The working range in Mesquite is $3,500 to $10,000 for a standard alcove conversion. Where you land depends on what’s already there.
- Basic alcove, acrylic pan and surround, keep valve: $3,500 to $5,000
- Tile walls, new valve, framed glass: $5,500 to $7,500
- Tiled pan, frameless glass, relocated drain: $8,000 to $10,000
- Plumbing or structural surprises (rotted subfloor, cracked cast iron, moved drain): add $800 to $3,000
Four things push a job toward the high end: moving the drain, replacing the valve wall because of old galvanized lines, reframing a non-standard alcove size, and going with a fully tiled pan and frameless glass. If your conversion is part of a larger Bathroom Remodeling in Mesquite project, we fold the shower scope into one written estimate so you’re not paying for two separate mobilizations.
Our written estimates list demo, rough-in, waterproofing, tile, fixtures, and permit fee as separate lines. What they don’t cover: structural repairs found after demo (we stop and quote those before proceeding), and moving the toilet or vanity, which is a different scope.
See the difference
Before
After
Before
After
Before
AfterWhat Mesquite’s Housing Stock Does to This Job
Mesquite is built out. It’s been essentially fully developed since the 1980s, which means the conversion work here is renovation, not new construction, and most of it is happening in 1950s through 1970s single-family ranches and brick-veneer tract homes. When we open a tub wall in a home near Town East Mall or in the neighborhoods off Belt Line Road, we’re usually looking at the original cast iron drain, a 1970s valve with a cross-handle, and a subfloor that’s been soaking for a decade under a slow tub leak.
The North Texas clay is a bigger factor than most homeowners expect. Black clay soil swells and shrinks through wet-dry cycles, and that movement shows up as door frames that don’t sit square and tile that cracks along grout lines. We check floor level before setting a pan, because a pan set on a moving slab will crack. Hail season doesn’t affect an interior shower, but it does mean a lot of Mesquite homeowners are budgeting multiple projects in the same year. When that’s the case, homeowners often pair an interior refresh with Metal Roofing in Mesquite or a hail-driven replacement handled through our bathroom and roofing crews on one schedule.
Serving Mesquite, TX – Our Local Coverage Area
We serve Mesquite and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Tub-to-Shower Conversion in Mesquite

Most conversions take 5 to 10 working days from demo to final inspection. Simple jobs with acrylic surrounds and no plumbing changes finish in 5. Full tile, a moved drain, and a new valve typically land at 8 to 10, and inspection scheduling can add a day or two.
Yes if plumbing or electrical changes. Mesquite requires a plumbing permit when the drain or valve is relocated or replaced, and the work gets inspected. Tile-only replacements on the existing pan and valve generally don’t require a permit, but we pull one whenever the work touches plumbing so you’re protected at resale.
Often yes. If the tub is a standard 60-inch alcove and the drain sits in the right spot for a shower pan, we keep the existing rough-in and skip the permit. The main limits are drain location (a center drain needs relocation), floor joist direction, and whether an interior wall needs to come down for a walk-in entry.
Between $3,500 and $10,000 for a standard alcove conversion, depending on pan type, tile, glass, and whether plumbing moves. Call (888) 426-8078 for an exact quote, estimates are free.
Every conversion we do is backed by the 730-Day Done Right Promise. If the waterproofing, tile, or plumbing we installed fails within that window, we come back and make it right. That’s one of the longest workmanship guarantees in the residential construction space.
Schedule Your Free Tub-to-Shower Conversion Estimate in Mesquite
Call (888) 426-8078 and a live person answers, day or night, no voicemail. We’ll set a time to walk your bathroom, measure the alcove, check the valve wall, and hand you a written line-item estimate before anyone picks up a hammer. Estimates are free. If your project is over $10,000, we’ll also walk you through the $1,000 off promotion and 0% financing for 18 months. Our technicians have up to 12 years of experience on this work, and every one of them is background-checked and arrives in uniform. We cover all of Mesquite and the surrounding area, and if your job grows into a fuller scope you can see our Bathroom Remodeling service page for the wider project. Windows are sometimes on the same punch list for these older homes; if so, our partners handle Tile Roofing in Mesquite and window work like Therma-Tru entry doors and ECO Window Systems units on the same visit.
Written by the team at Groundwork Construction Co.












