







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Rowlett, TX: What It Takes and What It Costs
Concrete driveways & concrete work in Rowlett typically run $4,500 – $12,000 for a standard driveway pour, and most residential jobs are finished – poured, cured, and ready to park on – in 5 to 8 working days from demo to final cure. The concrete itself goes down in a single day; the cure is what eats the calendar. Here’s what actually decides whether your job lands at the low or high end, and what the process looks like around Lake Ray Hubbard’s lot constraints. Call (888) 426-8078 for a free on-site estimate.
How a concrete driveway job actually runs, stage by stage

Most contractors tell you “we’ll handle it.” That’s not useful when you’re writing a check for five figures and wondering when you’ll be able to move your car. Here’s the real sequence, with the days and decisions that matter.
Stage 1: Site visit and layout (day 0, about 45 minutes)
We measure the existing driveway, check the slope away from the garage, and look at what’s buried underneath – sprinkler lines, gas runs to the grill, cable drops. In Rowlett’s older subdivisions this is where most surprises live: irrigation lines laid across the drive in the 1990s get clipped by demo equipment if nobody flags them first. You decide the width (10 feet is standard single-car, 16 feet if you want two cars to pass) and whether you’re expanding the apron to match a future widening.
Stage 2: Demolition and haul-off (day 1)
Existing concrete comes out with a skid-steer breaker and goes into a dumpster for haul-off. A typical 20-by-20-foot drive takes four to six hours. If there’s rebar in the old slab, it gets cut and pulled. You don’t need to be home for this – but do move vehicles the night before, and expect noise and dust.
Stage 3: Base prep and grading (day 2)
This is the stage that separates a driveway that lasts 30 years from one that cracks in year three. We excavate 4 to 6 inches of existing soil, bring in select fill, and compact it in lifts with a plate compactor. The base gets graded to a 1 to 2 percent slope away from the garage so water doesn’t pool at the door. In Rowlett’s blackland clay, we often go deeper on select fill than we would on sandy soil – that clay swells when wet and shrinks when dry, and a driveway sitting on unstable subgrade is a driveway that’s going to move.
Stage 4: Forming, rebar, and the pour (day 3)
Forms get set, #3 or #4 rebar goes in on a 12-to-18-inch grid, and the concrete arrives. A standard 400-square-foot driveway takes about 5 to 6 yards of 3,500-to-4,000 PSI ready-mix. The pour itself is a few hours. You decide the finish at this stage – broom, exposed aggregate, or a light salt finish. Control joints get cut within 12 to 24 hours, and those joints are not optional in North Texas; they’re what tells the slab where to crack instead of letting it crack wherever it wants.
Stage 5: Cure and cure time (days 4 through 8)
Concrete reaches about 70 percent of its design strength in the first week. You can walk on it after 24 to 48 hours. Light passenger cars are usually fine after 7 days. Heavy trucks and trailers want the full 28. We keep the slab damp for the first few days during hot weather, which is why July pours in Rowlett sometimes get a sprinkler running overnight. Final walkthrough happens once curing is well along and we can point out the joints, the slope, and the finish quality.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The concrete choices you’ll actually make
Concrete isn’t one product. Here’s what’s on the table for a Rowlett driveway, with the honest trade-offs:
- Standard broom finish – the workhorse. Grippy, hides tire marks well, and it’s what most subdivisions in 75088 and 75089 expect the driveway to look like. Cheapest finish. Not much visual character, but it holds up.
- Exposed aggregate – the top layer of cement paste gets washed away to reveal the stone underneath. More texture than broom, better traction on the slope up from the street, and it hides small cracks better. Adds meaningful cost over broom and it’s harder to patch cleanly later if you ever need a repair.
- Fiber mesh vs. rebar – fiber mesh is cheaper and helps with surface cracking, but rebar is what actually holds a slab together over decades of clay movement. For any driveway over about 300 square feet in Rowlett, we install rebar. Fiber-only slabs in blackland clay are a known shortcut, and we’ve replaced enough of them to know the difference.
- Slab thickness – 4 inches is fine for passenger vehicles. 5 to 6 inches if you park a truck, a boat trailer, or an RV. The cost difference is real (concrete is priced by the yard) but replacing a cracked slab costs more.
- Standard gray vs. integral color – integrally colored concrete (the pigment goes into the mix, not on top) runs more per yard but gives you a warm tone that doesn’t fade the way surface stains do. Worth it if the driveway is visible from the street and the house has stone or brick accents.
What Concrete Driveways & Concrete Work costs in Rowlett, TX

A standard concrete driveway installation in Rowlett runs $4,500 – $12,000. A full replacement (demo plus new pour) is $5,000 – $14,000. Below that, concrete walkways, patios, and small slabs typically price out per square foot.
| Line item | Typical Rowlett range |
|---|---|
| Standard concrete driveway installation | $4,500 – $12,000 |
| Full driveway replacement (demo + pour) | $5,000 – $14,000 |
| Concrete walkways and small slabs | Priced per square foot, quoted on site |
What pushes a job to the low vs. high end:
- Square footage and width. A 20-by-20-foot single drive and a 24-by-40-foot double with a turnaround aren’t the same job – concrete is priced by the yard, and more than double the area usually means close to double the cost.
- Demo and haul-off. If there’s existing concrete to break out and dumpster, that’s real labor. Slabs on tight lots with limited truck access cost more because the crew has to wheelbarrow.
- Site access. Rowlett’s buildable land is nearly exhausted, and most jobs happen on lots with mature trees, fences, and tight side yards. A driveway a concrete truck can’t reach easily means a pump truck, which adds cost.
- Finish and thickness. Exposed aggregate, integral color, and a 5- or 6-inch slab all push toward the high end. Broom finish at 4 inches keeps you toward the low end.
- Subgrade condition. Soft spots, old tree roots, or failed prior base mean more excavation and more select fill.
A written estimate from us lists concrete yardage, rebar spec, thickness, finish, demo, haul-off, and any permit fees separately. What’s not in a typical quote: irrigation line relocation, gas line reroutes, and any landscaping restoration after haul-off. Our pricing is upfront – the number you see is the number you pay. No change orders mid-pour.
See the difference
Before
After
Before
After
Before
AfterWhat Rowlett homes specifically do to this job
Rowlett is a Lake Ray Hubbard shoreline suburb that was largely farmland until the 1980s-to-2000s build-out. That history is written directly into the driveways we work on. Most of the housing stock in Waterview and the Peninsula is 1980s-to-2000s brick-veneer on a first-generation suburban slab, and the original driveways are showing their age: hairline cracks that have become wide cracks, settled corners at the apron, spalling at the control joints from 30-plus North Texas freeze-thaw cycles.
The blackland soil is the other big factor. North Texas clay swells when it’s wet and shrinks when it’s dry, and that movement drives most of the slab repair and driveway replacement demand we see in Rowlett. A slab poured on poorly compacted clay in 1994 looks fine in April and cracks wall-to-wall in August. On the lakefront side, the clay behaves even more aggressively – it shifts near the water table, and shoreline-adjacent jobs sometimes need engineering review the inland jobs on the same street don’t. Add in spring hail and straight-line winds, and you get the driveway / roof / retaining wall trifecta we see on a lot of Rowlett properties each storm season.
Rowlett’s buildable land is nearly exhausted, so new construction here is infill and teardown-rebuild work on tight remaining lots. That means we’re frequently pouring concrete in driveways squeezed between mature trees and established fences. If your project is part of a full Driveway & Pavers in Rowlett scope that includes a new patio or walkway extension, we sequence it all together so you’re not paying for a return trip. Our Driveway & Pavers service covers the broader scope; this page is the narrow concrete version. Homeowners often pair this with Garage Conversion ADU in Rowlett – a converted garage usually means the driveway needs to be reworked to serve as primary access. We serve the whole Rowlett area, including Sachse, Garland, Wylie, and Rockwall, and the New Detached ADU in Rowlett projects we do frequently include new concrete aprons and access drives.
Serving Rowlett, TX – Our Local Coverage Area
We serve Rowlett and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in Rowlett

Five to eight working days from demo to a drivable surface for a standard installation. The pour itself is one day (usually day 3), then 7 days of foot traffic before you park a car, and 28 days to full design strength for heavy vehicles. Weather can push it – summer heat and North Texas rain delays are real. Call (888) 426-8078 for a quote specific to your lot.
Replacing or widening a driveway on your own lot typically doesn’t require a building permit, but work in the public right-of-way (the apron and approach between your property line and the street) does, and so does anything touching a floodplain near Lake Ray Hubbard. We’ll tell you which bucket your job is in during the on-site estimate and handle the paperwork if a permit is needed.
Only if the existing slab is structurally sound and stable. Overlays (a thin new layer poured on top of the old one) are cheaper up front but fail fast in Rowlett’s blackland clay if the base slab has already settled or cracked. For a first-generation 1990s slab showing movement, demo-and-replace is usually the honest answer.
Not for the scope we quoted. Our written estimate is line-itemed, and the number you see is the number you pay – no change orders for concrete yardage, rebar, or finish unless you add scope or the site reveals something we couldn’t see before the pour (an unexpected buried gas line, for example). Every job is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right.
Every concrete driveway we pour is backed by the 730-Day Done Right Promise, one of the longest workmanship guarantees in the residential construction space. If a joint fails, a slab settles, or the finish isn’t what we agreed to, we come back and make it right. Calls are answered by a live person 24/7, so you’re not leaving a voicemail and waiting until Monday for a response.
Get a free estimate for concrete driveways & concrete work in Rowlett
Call (888) 426-8078 and you’ll reach a live person, any hour. We’ll set up a free on-site estimate at your Rowlett property, walk the lot, check the base and subgrade, and put together a written line-item quote with the concrete spec, finish, and timeline spelled out. No surprise change orders, no vague language. Financing is available at 0% for 18 months, and projects over $10,000 get $1,000 off. Concrete driveways & concrete work in Rowlett is what we do – let’s price yours.
Written by the team at Groundwork Construction Co.












