







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Walk-In Showers & Shower Remodeling in Rockwall, TX: What to Expect
A walk-in shower remodel in Rockwall, TX runs $9,000 – $28,000 for the full bathroom scope, with the shower itself typically landing between $4,500 – $12,000 for installation and $3,000 – $8,500 for a straight replacement. Most projects take 2 – 4 weeks from demo to final walkthrough, and a curbless, tiled, frameless-glass job usually sits near the top of that timeline. Call (888) 426-8078 for a free on-site estimate and a written line-item quote before any tile gets ordered.
How We Run a Shower Remodel, Stage by Stage

Walk-in showers & shower remodeling isn’t a one-visit job, and any contractor who tells you otherwise is skipping steps you’ll pay for later. Here’s the honest sequence we follow in Rockwall.
Stage 1: Site visit and measurements (day 1, about 90 minutes)
We measure the existing pan, check the drain location, confirm whether the valve is centered, and look at what’s behind the tile. We also test the subfloor for deflection and check for any soft spots near the curb. You decide the shower footprint at this visit: standard 36×60, a larger 48×60, or a curbless walk-in.
Stage 2: Demo and rough-in (days 2 – 3)
Tile and backer come out, the old pan gets cut free, and we expose the drain and valve. If you’re keeping the plumbing in the same location, this is fast. Moving the drain or relocating the valve adds a day or two and requires a plumbing permit. This is also when we discover the surprises: rotted subfloor, a failed pan liner that’s been leaking silently, or studs that need sistering.
Stage 3: Waterproofing and inspection (days 4 – 6)
This is the stage most homeowners never see and the one that determines whether the shower lasts. We install a bonded waterproofing membrane over cement backer, tape and seal every seam and corner, and flood-test the pan for 24 hours. A city inspector signs off on the pan and drain before any tile goes down. No exceptions.
Stage 4: Tile, glass, and fixtures (days 7 – 12)
Wall tile, floor tile, niche, bench, and then the glass. You’ll have already chosen tile and trim at the estimate stage, but glass templating happens after tile is set, so there’s a 5 – 7 day lead time on frameless panels. Fixtures go in once the glass is measured.
Stage 5: Final walkthrough (day 13 – 14)
We run the shower, check every drain slope, seal the grout, and walk you through the finished job. The 730-Day Done Right Promise covers the workmanship from that day forward: if water finds a way out, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Shape Your Shower
Most of the difference between a $9,000 and a $28,000 Rockwall shower comes down to what you pick in these categories. Here’s the honest trade-off on each.
- Tile type: Porcelain is the workhorse – dense, water-resistant, $4 – $12 per square foot installed. Natural stone (marble, travertine) runs $12 – $30 per square foot installed and needs sealing every year or two in a shower. It’s beautiful and it’s high-maintenance.
- Pan vs. curbless: A standard curbed pan is the reliable default and adds nothing to cost. A curbless design requires a recessed subfloor or a linear drain and adds $800 – $2,500 depending on how much floor has to be lowered.
- Glass: Framed glass keeps the cost down and hides a slightly out-of-square opening. Frameless 3/8-inch tempered glass is the look most Rockwall buyers want, at $800 – $2,000 more, and it demands a perfectly square opening. That’s why the framing and waterproofing stages matter.
- Drain style: A center drain is standard. A linear drain runs the length of one wall, allows a single-slope pan, and costs $400 – $1,200 more installed, but it lets you use larger-format floor tile without cutting it down to fit the slope.
- Fixtures: Kohler, Moen, and Delta all make reliable thermostatic valves. A pressure-balance valve is code minimum; a thermostatic valve that holds a set temperature is the upgrade most homeowners pick and costs $300 – $800 more in parts.
- Built-in extras: Niches, benches, grab bars, and a shower seat add $400 – $1,800. If this is an aging-in-place shower, put a solid backing in the wall now, even if you don’t install the grab bar yet. It’s a $50 fix during construction and a $500 fix later.
What Walk-In Showers & Shower Remodeling Costs in Rockwall, TX

The full walk-in shower remodel range in Rockwall is $9,000 – $28,000. Here’s what moves a job to the low or high end.
- Size and configuration: A 36×60 alcove replacement sits near $9,000. A 48×60 curbless with a bench, niche, and linear drain runs $20,000 – $28,000.
- Existing condition: A failed pan liner that’s been leaking for years can mean $1,500 – $3,500 in subfloor and framing repair.
- Plumbing relocation: Moving the drain or valve adds $800 – $2,500 plus the permit and inspection time.
- Material grade: Porcelain versus slab marble can swing the tile line item by $6,000 – $10,000.
- Permit scope: A like-for-like shower replacement may not need a permit in some jurisdictions; a curbless, curb-moved, or drain-relocated job always does. We pull the permits and pass the inspections.
What’s in a written estimate: demo, haul-away, backer and waterproofing, flood test, tile and setting materials, glass, fixtures you selected, trim, permits, and clean-up. What’s typically not: tile and fixtures if you’re sourcing them yourself, and unforeseen structural repair, which we quote in writing before we start, never as a surprise change order.
See the difference
Before
After
Before
After
Before
AfterWhat Rockwall Homes Specifically Do to This Job
Rockwall is the only city in the Dallas – Fort Worth metro built entirely around a 22,000-acre lake, and that shapes how we build a shower here. In the 1990s – 2000s brick-and-stone subdivisions of Stone Creek and Chandler’s Landing, most of the shower failures we see trace back to one thing: North Texas clay soils that shrink and swell through the wet-dry cycle. That movement shows up in a shower as a fine crack at the curb or a grout line that opens along the pan. On the older pier-and-beam lake cottages along the original shore streets of 75032, we’re often working on a floor that flexes under foot, which means the pan has to be built with deflection in mind, not just waterproofed.
Down near the water, if your project runs into any structural relocation on the lake side, expect a paperwork layer most DFW contractors never encounter inland: Corps of Engineers shoreline permitting and City of Rockwall dock and boathouse regulations can come into play. We flag that at the estimate stage so it doesn’t stall the job in week two.
If the wider bathroom is getting pulled apart while we’re in there, we handle that as part of a full Bathroom Remodeling in Rockwall scope, and homeowners often pair this with exterior work like Roof Replacement & Installation in Rockwall when hail damage has them opening a project file anyway. Our Bathroom Remodeling team covers Rockwall and the surrounding communities of Heath, Fate, Royse City, and Rowlett. If you’re building a prefab ADU and want a shower spec matched to it, brands like Boxabl and Mighty Buildings are worth a look, and the same durable, low-maintenance logic applies.
Serving Rockwall, TX – Our Local Coverage Area
We serve Rockwall and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Walk-In Showers & Shower Remodeling in Rockwall

Most walk-in showers & shower remodeling projects in Rockwall take 2 – 4 weeks from demo to final walkthrough, with the glass lead time being the usual bottleneck. A straight shower replacement can finish in 10 – 14 days. Call (888) 426-8078 for a schedule that fits your timeline – estimates are free.
A like-for-like replacement sometimes doesn’t require one, but any job that relocates the drain or valve, changes the curb, or cuts framing does. We pull the permits and pass the inspections, and we tell you at the estimate which category your job falls into. Call (888) 426-8078 to review your specific situation.
Yes, and that’s the most common job we do. Keeping the drain and valve in place, re-waterproofing the pan, and replacing tile and glass gives you a fully rebuilt shower without touching the rough-in. It saves $800 – $2,500 versus a relocated layout. Call (888) 426-8078 to see which option fits your bathroom.
A walk-in shower installation in Rockwall runs $4,500 – $12,000, and a full shower remodel in the context of a bathroom renovation runs $9,000 – $28,000. The variables are size, tile grade, glass type, and whether the drain has to move. Call (888) 426-8078 for an exact quote – estimates are free.
Every shower remodel we do is covered by the 730-Day Done Right Promise: if the workmanship fails, we make it right. That’s one of the longest workmanship guarantees in the residential construction space, and it covers the waterproofing, tile, and fixture installation we perform. Call (888) 426-8078 to talk through the details.
Get a Free Walk-In Shower Estimate in Rockwall
Book a free on-site estimate for Walk-In Showers & Shower Remodeling in Rockwall by calling (888) 426-8078. A live person answers around the clock. On the visit, we measure the space, check the pan and drain, identify any repair items behind the tile, and hand you a written line-item quote. You’ll know exactly what the job costs before any material is ordered, and you’ll see where our Metal Roofing in Rockwall team can help if exterior work is also on the list.
Written by the team at Groundwork Construction Co.












