







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Princeton, TX: What It Takes and What It Costs
Replacing a vanity, retiling a bath floor or shower surround, and swapping fixtures in Princeton typically runs $9,000 – $28,000 for a full bathroom’s worth of work, or $800 – $3,000 for a vanity on its own. Most of these jobs run two to four weeks once materials are on site. Call (888) 426-8078 and we’ll set a free on-site estimate with a written, line-item quote.
How the Work Actually Runs, Stage by Stage

Sit-down estimate first, then a written scope. A bathroom’s worth of vanities, tile, and fixtures breaks into five stages, and each one has a decision that’s yours to make before we move on.
1. Estimating and material selection (day 1, about 90 minutes)
We measure the room, check what’s behind the existing vanity, and photograph the subfloor and any wet areas. Then we price the job in writing, line by line, so you’re comparing the same scope across bids. Picking the vanity, tile, and fixtures happens here or in the week after. The number you see is the number you pay.
2. Demo and rough-in (days 2 – 4)
Out comes the old vanity, toilet, and floor tile. If plumbing or electrical has to move for a wider vanity or a new sconce, this is the stage where it happens, because drywall doesn’t go back up until it’s done. We open the wall, not guess through it. Typical demo is one to two days; relocating a drain or adding a circuit adds a day or two.
3. Substrate and waterproofing (days 4 – 7)
New cement board or a bonded waterproofing membrane goes in the wet areas, and the floor gets leveled or patched to take tile. On a slab in Princeton, this is also where we check for cracks or movement, because they telegraph straight through thin tile. We don’t set a single tile until that layer is right.
4. Tile and vanity setting (days 7 – 14)
Floor tile first, then wall tile or a shower surround, then the vanity cabinet and top. Grout and sealant last, with a full cure before water touches it. Layout is a decision you’ll want to make with us early. Running tile on a diagonal or centering it on the room costs a bit more in waste and labor, but it changes how the whole room reads.
5. Fixtures, punch list, and walkthrough (days 14 – 20)
Faucets, shower trim, lighting, mirrors, and towel bars go in, then we run water and test everything before we call the job done. You get a walkthrough and a punch list, and anything on it gets fixed before final payment. The whole job sits under our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of the budget swings live in these picks, and each one is a real trade-off, not a style preference.
- Vanity grade and layout. A stock cabinet with a laminate top lands at the low end of the $800 – $3,000 range. A semi-custom cabinet with a quartz top and a ceramic undermount sink runs toward the top. Freestanding vs. built-in matters too, because built-in usually means adjusting plumbing.
- Countertop surface. Quartz is the common choice because it holds up to water and cleaning without sealing. Silestone and Caesarstone both make strong quartz lines, and you’ll see them in showrooms across Collin County. Granite is beautiful but wants periodic sealing. Porcelain slabs resist stains well but chip at edges if you’re rough on them.
- Floor tile. Porcelain is the workhorse. It’s dense, handles moisture, and comes in large formats that make a small room feel bigger. Natural stone is gorgeous and needs sealing and a little care. Large-format tile (12×24 and up) cuts grout lines and looks cleaner, but it needs a flatter substrate and costs more in labor.
- Shower wall tile. Ceramic is the budget pick and fine for a guest bath. Porcelain and glass mosaic hold up better with daily use. Grout choice matters as much as tile: epoxy grout resists staining and mildew far better than cement grout in a hard-working shower.
- Faucets and trim. Kohler and Moen both make reliable, widely serviced lines. A mid-grade faucet with a solid brass body lasts meaningfully longer than a builder-grade one, and it’s one of the cheapest upgrades on the list.
What Vanities, Tile & Fixtures Costs in Princeton, TX

For a full bathroom’s worth of vanities, tile, and fixtures in Princeton, expect $9,000 – $28,000. A vanity-only job runs $800 – $3,000. A walk-in shower installation, if that’s part of the scope, sits at $4,500 – $12,000. We price the whole scope in writing before the first tile comes up.
Four variables push a job toward the low or high end:
- Room size and tile area. A 5×8 hall bath and a 10×12 primary bath are different jobs. Square footage of tile drives both material and labor.
- Moving plumbing or electrical. Keeping the drain and supply lines where they are keeps the number low. Relocating a vanity wall or adding a circuit adds real labor and permit scope.
- Material grade. Stock vanity and porcelain vs. semi-custom and quartz is a several-thousand-dollar swing on its own.
- Existing condition. Rotted subfloor, old galvanized supply lines, or a shower pan that was never waterproofed correctly all add demo and prep time.
A written estimate covers demo, rough-in, substrate, tile setting, vanity install, fixture install, and cleanup. It typically doesn’t cover the cost of the tile itself if you’re sourcing your own, structural repairs found behind the wall, or a permit if one turns out to be required.
See the difference
Before
After
Before
After
Before
AfterWhat Princeton Homes Specifically Do to This Job
Princeton (ZIP 75407) sits in fast-growing Collin County ranch country east of McKinney, and that shows up in the work. A lot of what we touch is new tract-home construction on former blackland-prairie pasture, which means builder-grade vanities, builder-grade tile, and the standard set of shortcuts that come with a fast subdivision buildout. Those shortcuts show up as grout that cracks in the first year, a shower pan that was never properly waterproofed, and a vanity that wasn’t shimmed level on a less-than-flat floor.
The other half of Princeton’s housing stock is older rural ranch and manufactured homes on acreage, where we regularly see 1990s-era fixtures, dated tile, and supply lines that are due for an upgrade while the wall is already open. Blackland clay is the shared factor: it expands when wet and cracks when dry, so slabs move, and that movement telegraphs through floor tile and vanity bases. We check for it and address it during substrate prep, not after the tile fails.
This job often comes up as part of a full Bathroom Remodeling in Princeton, and if you’re planning exterior work at the same time, homeowners often pair this with Tile Roofing in Princeton or Specialty Roofing in Princeton while the crew is already on site. Our bathroom remodeling service covers the wider scope, and we handle vanities, tile, and fixtures throughout Princeton.
Serving Princeton, TX – Our Local Coverage Area
We serve Princeton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Princeton

Two to four weeks for a full bathroom’s worth of work, from demo to final walkthrough. A vanity-only installation is usually a single day. Tile work is what drives the timeline, because grout and waterproofing need cure time you can’t rush. Call (888) 426-8078 for a schedule based on your actual scope.
Cosmetic tile and fixture swaps generally don’t, but moving plumbing or electrical typically does, and your jurisdiction sets the rule. We pull the permit when one’s required and pass the inspection before we close the wall. Call (888) 426-8078 and we’ll tell you what your specific job needs.
Yes, and it’s the most common way we handle vanities, tile & fixtures. If you’re keeping the existing layout and just upgrading the finishes and fixtures, no plumbing relocation is needed and the cost stays at the low end of the range. Call (888) 426-8078 for an estimate on a layout-keeping job.
Bathroom vanity installation in Princeton runs $800 – $3,000, depending on size, cabinet grade, and countertop material. A stock vanity with a quartz top sits near the bottom of that range. Call (888) 426-8078 for an exact quote, and the estimate is free.
Every job is covered by our 730-Day Done Right Promise, one of the longest workmanship guarantees in the residential construction space. If something we installed isn’t right, we make it right, and we answer the phone 24/7 with a live person. Call (888) 426-8078 to schedule your free estimate.
Get a Free Estimate on Vanities, Tile & Fixtures in Princeton
Call (888) 426-8078 and we’ll schedule a free on-site estimate for your vanities, tile, and fixtures in Princeton. We’ll measure the room, walk through the material options, and leave you with a written, line-item quote and no surprise numbers later. Financing at 0% for 18 months is available, plus $1,000 off projects over $10,000. Real people answer the phone, day or night.
Written by the team at Groundwork Construction Co.












