







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Seagoville, TX: What It Really Takes
A tub-to-shower conversion in Seagoville runs $3,500 – $10,000 and takes about 5 to 10 working days once demolition starts. The job means pulling the tub, reworking the drain and valve to shower height, prepping and waterproofing the wet area, setting a new pan or curbless base, tiling, and hanging glass or a curtain rod. In the older small brick ranches along US 175 that usually means a tub alcove that was never built for a shower pan. Call (888) 426-8078 to schedule a free on-site estimate and get a written line-item quote before any demo starts.
How a Tub-to-Shower Conversion Actually Goes, Stage by Stage

Most contractors hand you a start date and a vague finish. We’d rather tell you exactly what happens on which day so you can plan around it. Here’s the sequence we follow on a standard Seagoville conversion.
Stage 1: Measure and confirm the layout (before any work)
We measure the alcove, check the drain location and whether the existing valve is centered or offset, and verify the slab or subfloor under the tub is sound. On Seagoville’s older stock this is where we find the surprises – rotted subfloor at the tub edge, a drain that sits too far forward for a standard pan, or a valve that has to move to hit shower height. You decide at this stage whether you want a curb or curbless entry, and roughly what tile look you’re after. A permit gets pulled here if the plumbing is being reconfigured.
Stage 2: Demolition and rough-in (days 1 – 2)
Out comes the tub, the surround, and any drywall behind it. We open the wall enough to see the valve and supply lines, then set the new drain and shower valve. If you’re converting a standard 60-inch alcove, the rough-in is usually a day. If we’re moving the drain or adding a bench, plan on two. This is the point where a real quote either holds or starts climbing – and it’s why a written estimate that accounts for the “what if we find rot” scenario matters.
Stage 3: Waterproofing and inspection (days 3 – 4)
Cement board goes up, then a bonded waterproofing membrane over the walls and pan, with the seams taped and sealed. The pan gets a flood test. If the job needed a plumbing permit, the rough-in inspection happens before the walls close. Skipping this stage is how showers leak into the room below three years later. We don’t skip it.
Stage 4: Tile and finish (days 4 – 7)
Wall tile, floor tile, grout, and the valve trim and showerhead. You’ll make your final selections – tile, grout color, fixture finish – before this stage, not during it, because special-order tile can add a week of lead time. This is the stage where a $3,500 job and an $8,000 job start to look different, and it’s mostly about tile grade and fixture brand, not labor.
Stage 5: Glass, punch list, and walkthrough (days 8 – 10)
Glass panels or a framed door go in, silicone cures, and we walk the job with you testing the drain, checking the valve, and confirming the grout lines. Final inspection happens here if one was required. You get the 730-Day Done Right Promise in writing – if a seam fails or the pan leaks, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between on a Seagoville Conversion
Every tub-to-shower conversion comes down to about five decisions. Here’s what actually matters and what each choice costs you in money and durability.
- Pre-formed pan vs. tiled mud-set pan. A pre-formed acrylic or composite pan installs in hours and costs less; it’s the practical choice for a rental or a fast flip. A tiled pan lets you match the floor to the walls and holds up better long-term, but adds labor and a few days. For a house you plan to keep, tiled wins.
- Standard alcove vs. curbless entry. A curb keeps the conversion simple and keeps the drain height. A curbless (zero-threshold) shower looks cleaner and is safer for aging in place, but requires lowering the drain and framing the floor to slope – budget an extra 15 – 25% for that.
- Tile grade. Porcelain is the workhorse: dense, water-resistant, and priced reasonably. Natural stone (travertine, marble) looks stunning but needs sealing every year or two and costs noticeably more per square foot.
- Fixture finish and brand. Kohler and Moen both make reliable valve and trim systems that hold up in North Texas water. A mid-grade valve with a good cartridge beats a fancy trim on a cheap valve every time.
- Glass. A fixed panel plus a hinged door is the standard. Frameless glass looks best; framed glass costs less and hides minor wall irregularities common in older Seagoville homes.
We carry a curated set of brand partners across every trade, which means you’re choosing quality, not just what a supply house had in stock that week.
What Tub-to-Shower Conversion Costs in Seagoville, TX

Tub-to-Shower Conversion in Seagoville typically falls between $3,500 and $10,000. That range covers a straight swap in an existing alcove up to a fully tiled, curbless, glass-enclosed conversion with new plumbing.
| Line item | Typical range |
|---|---|
| Basic acrylic pan + surround conversion | $3,500 – $5,500 |
| Tiled alcove conversion with new valve | $5,500 – $8,000 |
| Curbless tiled conversion with glass | $8,000 – $10,000+ |
| Drain or valve relocation (add) | $400 – $900 |
| Subfloor or framing repair (add) | $300 – $1,200 |
What pushes a job to the top of that range: reconfiguring the drain or supply lines, a curbless entry, premium tile or natural stone, and a frameless glass enclosure. What keeps it low: keeping the existing drain location, a pre-formed pan, and porcelain tile. A written estimate from us breaks out labor, material, permit fees, and disposal so you see every line. The number you see is the number you pay – no change orders unless you approve a change in scope.
This job is often part of a full Bathroom Remodeling in Seagoville if the vanity, floor, or lighting is on the same list – and it’s worth pricing the two together since the demo overlaps. If you’re only changing the tub, converting it stays a stand-alone job and a much smaller bill.
See the difference
Before
After
Before
After
Before
AfterWhat Seagoville Homes Specifically Do to This Job
Seagoville straddles the Dallas – Kaufman county line, and construction here is shaped by two things: the expansive Blackland Prairie clay under every slab and the two-county permitting reality. On a tub-to-shower conversion, that clay matters more than most homeowners expect. Slabs move, and a tub alcove that was set years ago may now be out of level. We check for that before setting a pan, because a shower that drains poorly is almost always a floor that moved, not a bad tile job.
The housing mix drives the work too. The mid-century small brick ranches and 1970s – 80s frame homes in the older core along US 175 are where we do the most conversions – original cast-iron drains, offset valves, and tub surrounds that were never designed for a modern shower pan. The newer tract subdivisions on the east and south edges of town tend to have builder-grade acrylic surrounds that fail at the seams. And because lots near the county line can fall on the Dallas side or the Kaufman side, the permit office and inspection schedule for your specific address can differ block to block. We pull the permit and pass the inspection either way, and we check which county your lot sits in before we schedule the rough-in inspection.
Summer schedules here work around extreme heat, and spring storm season can bump exterior work – which is part of why a bathroom conversion is a smart warm-weather job. Homeowners often pair this with Metal Roofing in Seagoville or Tile Roofing in Seagoville when they’re refreshing the whole house at once.
Serving Seagoville, TX – Our Local Coverage Area
We serve Seagoville and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Tub-to-Shower Conversion in Seagoville

A standard conversion takes 5 to 10 working days from demo to final walkthrough. A basic acrylic swap can finish closer to 5 days; a fully tiled curbless shower with glass runs toward the 10-day end. Add a week if special-order tile is involved. Call (888) 426-8078 for a realistic schedule on your specific bathroom.
You need a plumbing permit if the drain or supply lines move, and Seagoville addresses on the Dallas – Kaufman county line may route through different offices. We pull the permit and pass the inspection as part of the job – it’s included in the written estimate, not billed as a surprise later. Call (888) 426-8078 to confirm what your address requires.
Yes, in most cases. If the existing drain and valve sit where a shower needs them, we keep the rough-in and avoid the biggest cost driver. If the drain sits too far forward or the valve is offset, we relocate – which adds $400 – $900. We know which before demo starts. Call (888) 426-8078 for a free on-site assessment.
Most jobs land between $3,500 and $10,000, depending on pan type, tile grade, glass, and whether plumbing moves. You get a written line-item quote before any work begins, and the number you see is the number you pay. Call (888) 426-8078 for a free estimate – no obligation.
Every conversion is covered by our 730-Day Done Right Promise – if the pan leaks or a seam fails, we make it right. That’s workmanship coverage, in writing, on top of the manufacturer warranty on the valve and fixtures. Call (888) 426-8078 with questions about coverage on your project.
Get a Free Tub-to-Shower Conversion Estimate in Seagoville
Call (888) 426-8078 and a live person answers, day or night. We’ll schedule a free on-site estimate, measure your alcove, check the drain and subfloor, and hand you a written line-item quote with the permit and disposal built in. No pressure, no vague numbers. If you’re weighing the conversion against a wider remodel, see our Bathroom Remodeling service or the full Seagoville service area for everything else we handle locally. Financing at 0% for 18 months is available, and projects over $10,000 get $1,000 off.
Written by the team at Groundwork Construction Co.












