







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Walk-In Showers & Shower Remodeling in Balch Springs, TX
Walk-in showers & shower remodeling in Balch Springs typically run $9,000 – $28,000, with most curbless or low-threshold conversions landing in the $9,000 – $16,000 range and full wet-room builds with tile and frameless glass reaching past $20,000. The work itself takes 8 to 14 working days from demo to final seal and inspection. Call (888) 426-8078 and we’ll walk your shower, take measurements, and put a written number in your hands before you commit to anything.
How a walk-in shower gets built here, stage by stage

Every shower we build in Balch Springs follows the same five-stage sequence. The timing shifts a little depending on tile size and glass lead times, but the order never does.
Stage 1: Demo and inspection (1 – 2 days)
We pull the old surround, tub, or tile down to the studs and the subfloor, then inspect what’s behind it. In Balch Springs, that inspection matters more than it does in newer suburbs. Original 1960s and 1970s plumbing shows up more often than not, and a slow leak behind a 40-year-old valve has usually been doing quiet damage for years. If we find rotted framing or a soft subfloor, you’ll see it in photos and in a written line item before anything gets covered back up. You decide there whether to repair or replace the valve and drain rough-in.
Stage 2: Rough-in and framing (1 – 2 days)
If you’re relocating the drain, adding a linear drain, or moving the valve to a different wall, this is when it happens. Plumbing gets roughed, blocking goes in for grab bars and a bench seat, and the framing gets squared. On a curbless design we recess the floor or build a slight slope into the subfloor. You’ll pick the drain location and bench configuration before this stage starts. Changing it later means redoing waterproofing, and nobody wants that bill.
Stage 3: Waterproofing and inspection (1 – 2 days)
This is the stage homeowners can’t see and shouldn’t skip. We install a bonded waterproofing membrane over cement board or a foam shower board system, band every seam and corner, and flood-test the pan. A Balch Springs inspection happens here if the job requires a permit, and we schedule it so the inspector sees the membrane before tile hides it. You don’t have to be home for that inspection. We coordinate it and send you the result.
Stage 4: Tile and finishes (3 – 5 days)
Wall tile, floor tile, niche, trim, and grout. Large-format porcelain goes up faster than mosaics, and a herringbone pattern adds a day or two on its own. We set the valve trim and showerhead during this stage as well. This is where you’ll want to have your grout color and tile layout locked in, and we’ll confirm both in writing before the first tile goes on the wall.
Stage 5: Glass, sealant, and final walkthrough (1 – 3 days)
Tempered glass panels and doors get installed, then silicone, then a full water test and a walkthrough with you. Custom glass takes 7 to 10 business days to fabricate, which is why we template it early and why the glass is often the last thing on site. At the walkthrough we check drainage, look at every grout line, and hand you the care instructions. Our technicians carry up to 12 years of experience on these builds, and the crew that sets your glass is the same one that waterproofed the pan.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The choices you’ll actually make on a Balch Springs shower
Most of the budget decisions happen in one sitting before demo starts. Here’s what you’re really choosing between.
- Tile material: Porcelain runs $4 – $12 per square foot installed and handles the humidity well. Natural stone like marble or travertine runs $12 – $30 per square foot, looks richer, and needs sealing every 1 – 2 years in this climate. Ceramic is the budget pick at $3 – $8 but chips more easily.
- Base type: A preformed acrylic or fiberglass pan is the cheapest and fastest, $600 – $1,200 for the pan alone. A tiled mud-set pan or foam board base costs $1,200 – $2,500 and lets you match the floor tile and slope the drain exactly where you want it. Curbless adds $1,000 – $2,500 for the floor recess and framing.
- Glass: Frameless tempered glass is the most popular, $1,500 – $3,500 for a typical walk-in. Semi-frameless saves $600 – $1,000 and still looks clean. A fixed panel with no door (a true walk-in) drops cost but needs 36 inches of clearance and a properly sloped floor.
- Fixtures: A standard pressure-balance valve and trim runs $250 – $600. A thermostatic valve with a rain head and hand shower combo runs $800 – $2,000. Kohler, Moen, and Delta all make reliable mid-tier options; splurging on the valve body matters more than splurging on the trim.
- Ventilation: A properly sized exhaust fan, $200 – $500 installed, is what keeps a walk-in shower from growing mildew in a Balch Springs summer. Don’t skip it, and don’t undersize it.
What Walk-In Showers & Shower Remodeling costs in Balch Springs, TX

Expect $9,000 – $28,000 for a walk-in shower or shower remodel in Balch Springs, with the middle of that range landing around $13,000 – $17,000. A straight shower replacement without moving anything is $3,000 – $8,500. A walk-in shower installation from scratch runs $4,500 – $12,000. A tub-to-shower conversion is $3,500 – $10,000. Those are real Balch Springs numbers, not national averages.
What pushes a job toward the top of the range:
- Size and layout: A 4×4 shower is the baseline. A 5×6 wet-room build with a bench and two showerheads adds framing, tile, and glass area, easily $3,000 – $6,000 more.
- What’s behind the wall: Rotted framing, old galvanized pipe, or a soft subfloor adds $800 – $3,000 once it’s uncovered.
- Moving plumbing or structure: Relocating the drain, valve, or a wall adds $1,000 – $4,000 depending on how far.
- Material grade: Porcelain and acrylic sit at the low end. Marble, frameless glass, and linear drains push toward the ceiling.
- Permit scope: A permit adds roughly $150 – $450 in fees, plus the inspection visit. We pull it and pass it, but it’s in the estimate from day one, not a surprise later.
Every written estimate we hand you is line-itemed and fixed. The number you see is the number you pay. If the price needs to change because hidden damage shows up, we bring you a written change order and you approve it before we continue. Nothing gets added after the fact. The $1,000 off projects over $10,000 promotion applies to most of these builds, and 0% financing for 18 months is available if you’d rather spread the cost.
See the difference
Before
After
Before
After
Before
AfterWhat Balch Springs homes do to this job
Balch Springs sits in the Texas blackland prairie, where expansive clay soils shrink and swell dramatically with the wet-dry cycle. That’s the thing that defines construction here, and it shows up in shower work too. After heavy rains, pier-and-beam homes in older neighborhoods near the 75180 ZIP shift and settle, and a settled floor is exactly what you don’t want under a tiled shower pan. We check floor level during the estimate, and when a shower floor is out of level by more than a half inch we correct the subfloor before waterproofing. Otherwise the water pools at the wrong end of the drain and the tile starts to hairline crack within a season.
Most of the homes we remodel showers in are 1950s through 1970s single-story ranches, often on pier-and-beam or shallow slab, and often still running original plumbing. The hot, humid summers accelerate wood rot and pest damage behind tile, and heavy rains push moisture into wall cavities, so we treat moisture management as part of the shower build rather than an afterthought. If your shower project is part of a full Bathroom Remodeling in Balch Springs job, the same water-damage and floor-level checks apply to the rest of the room. And because a shower leak that finds a ceiling often finds roofing problems at the same time, homeowners often pair this with Roof Replacement & Installation in Balch Springs when the ceiling above shows staining. If you’re reworking the exterior while you’re at it, Metal Roofing in Balch Springs is another one we handle. Outside the shower itself, this is a narrow job, so we scope it as part of our Bathroom Remodeling service rather than pretending a shower is the whole answer, and you can see the full range of what we cover on our Balch Springs page.
Serving Balch Springs, TX – Our Local Coverage Area
We serve Balch Springs and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Walk-In Showers & Shower Remodeling in Balch Springs

A walk-in shower remodel takes 8 to 14 working days for most Balch Springs jobs, from demo through final seal. Add 7 to 10 business days of the window for custom glass fabrication, though we run other work in that gap so you’re not sitting idle. Permits can add a few days to the inspection schedule. Call (888) 426-8078 and we’ll give you a calendar date, not a vague window.
Yes, if you’re moving or replacing the plumbing, adding a drain, or changing the shower’s footprint, Balch Springs requires a permit and an inspection of the waterproofing before tile goes up. A cosmetic swap of tile and glass over an existing code-compliant shower often doesn’t require one. We determine which applies during the estimate and pull the permit for you when it’s needed. Call (888) 426-8078 to schedule yours.
Yes. If your current drain and valve are in workable locations, we can build a walk-in shower around them, which keeps the job at the lower end of the $4,500 – $12,000 walk-in range and shaves 2 to 3 days off the timeline. Moving the drain or valve is what adds $1,000 – $4,000 and usually requires a permit. We’ll tell you honestly at the estimate which situation you’re in.
Walk-in shower installation in Balch Springs runs $4,500 – $12,000, a shower replacement runs $3,000 – $8,500, and a tub-to-shower conversion runs $3,500 – $10,000. Full walk-in showers & shower remodeling projects that include tile, glass, and fixture upgrades land in the $9,000 – $28,000 range. Call (888) 426-8078 for an exact quote. Estimates are free.
Every shower we build in Balch Springs is covered by our 730-Day Done Right Promise. If the waterproofing, tile, or installation fails within that window because of our workmanship, we come back and make it right. Manufacturer warranties on the valve, fixtures, and glass apply separately and we hand you the paperwork. Call (888) 426-8078 with the details and we’ll get a free estimate on the calendar.
Get a free estimate on your Balch Springs shower
Walk-In Showers & Shower Remodeling in Balch Springs starts with a visit, not a phone quote. We’ll measure your shower, check the floor level, look at the plumbing behind the wall, and leave you with a written line-item estimate and a calendar date. Call (888) 426-8078 and a live person answers, any hour. The estimate and design consult are free.
Written by the team at Groundwork Construction Co.












