







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Walk-In Showers & Shower Remodeling in Rowlett: Cost, Timeline, and What to Expect
Walk-In Showers & Shower Remodeling in Rowlett typically runs $9,000 – $28,000 for a full master-bath shower rebuild, while a shower-only replacement with new pan, tile, and glass usually lands between $4,500 and $12,000. Most jobs take 5 to 10 working days on site once materials are in hand. For an exact number on your Rowlett bathroom, call (888) 426-8078 and we’ll set up a free on-site estimate.
How We Run a Shower Remodel, Start to Finish

Every Rowlett shower remodel follows the same five-stage sequence. The durations below are typical for a standard master-bath shower; larger customs run longer, and that’s called out at each stage.
Stage 1: On-site estimate and written scope (day 0)
We measure the existing footprint, photograph the drain and valve rough-in, and confirm whether you’re keeping the shower in the same spot or shifting it. You’ll get a written line-item quote with the pan, tile, valve, glass, and labor broken out, not a single lump figure. The decision you make here is the scope: shower-only, or part of a Bathroom Remodeling in Rowlett that touches the tub, vanity, and floor at the same time.
Stage 2: Demo and inspection (day 1)
We pull the old shower out to the studs. For 1980s and 1990s Rowlett homes, that means hauling out a fiberglass unit or a tile-over-greenboard job, both of which we see constantly. The exposed framing and drain get checked for rot and improper slope before anything new goes back in. Typically one full day.
Stage 3: Rough-in and waterproofing (days 2 – 3)
New valve, drain, and any relocated plumbing get set here. If you’re moving the shower head to the opposite wall or adding a bench, this is when the framing changes happen. Then comes the waterproofing system: a bonded membrane or a foam pan and board system, both of which get flood-tested. You decide the valve brand and finish now, since the rough-in has to match. One to two days.
Stage 4: Tile and finishes (days 4 – 7)
Wall tile, floor tile, niche, and curb get set. Large-format tile moves faster than a mosaic pattern with hundreds of pieces; a custom mud-set pan runs longer. Grout and caulk need a full day to cure before glass goes on, so this stage is the biggest schedule variable. Three to four days for most Rowlett showers, longer for large-format or herringbone patterns.
Stage 5: Glass, trim, and punch walk (days 8 – 10)
Frameless or semi-frameless glass gets templated earlier in the job and installed last, along with the shower head, valve trim, and any grab bars. We walk the finished shower with you before we close the job. The 730-Day Done Right Promise covers the workmanship from that walk-through.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for a Rowlett Walk-In Shower
Here’s what actually gets decided on a Rowlett job and what each choice means for cost and longevity.
- Tile vs. solid-surface panels. Porcelain or ceramic tile gives you the widest design range and runs $2,000 – $6,000 in material and labor for a standard shower. Solid-surface panels (acrylic or a cultured marble) cost less and go in faster, but show scratches and feel less custom.
- Frameless vs. semi-frameless glass. Frameless 3/8-inch glass looks clean and holds up in a master bath; semi-frameless saves $400 – $900 but shows more metal and a heavier top rail. Mr-Glass and local glaziers both template off the finished tile, so the glass is measured after the tile is up.
- Linear drain vs. center drain. A linear drain lets you run large-format floor tile with a single slope, which reads cleaner. It adds $300 – $800 to the rough-in and pan work. A center drain is simpler and cheaper if you’re not chasing a specific look.
- Curbless vs. low curb. A true curbless shower requires recessing the floor framing or building up a sloped pan, adding $1,200 – $2,500. It’s worth it for aging-in-place or if you want a seamless look; a 4-inch curb with a bench handles most homeowners fine.
- Built-in bench, niche, and rain head. Each is a small line item that adds up: a tiled bench $400 – $900, a recessed niche $150 – $400, a rain shower head and diverter $300 – $700.
- Valve and fixture brand. A mid-tier valve and trim from Kohler or a comparable line runs $250 – $600 and carries a real warranty. Cheap import valves are the number one cause of callbacks we see on remodels.
What Walk-In Showers & Shower Remodeling Costs in Rowlett, TX

Walk-In Showers & Shower Remodeling in Rowlett runs $9,000 – $28,000. A shower-only replacement with new pan, tile, and glass falls in the $4,500 – $12,000 range. The spread comes down to five variables.
Size and configuration. A 36×48 alcove is at the low end; a 5×6 walk-in with a bench and dual heads is at the top. Existing condition. Rotted framing, a failed pan, or a drain that has to be re-sloped adds demo and repair time. Moving plumbing or electrical. Relocating the drain, valve, or a light fixture above the shower adds $800 – $2,500 and changes the permit scope. Material grade. Large-format porcelain, natural stone, and frameless glass occupy the upper band; ceramic and semi-frameless sit lower. Permit scope. A shower in the same spot is typically a simpler permit; moving the drain or adding a light typically requires an inspection.
Our written estimate covers demo, waterproofing, tile, grout, fixtures, and glass install. It does not cover structural repairs found behind the wall, a full bathroom floor or vanity remodel (that’s the broader Bathroom Remodeling scope), or HOA fees. No surprise change orders: the number you see is the number you pay, and the 730-Day Done Right Promise backs the install.
See the difference
Before
After
Before
After
Before
AfterWhat Rowlett Homes Specifically Do to This Job
Most of the showers we tear out in Rowlett sit in 1980s-to-2000s brick-veneer homes across subdivisions like Waterview and the Peninsula, and the failure pattern is predictable. First-generation fiberglass pans from that era crack and leak at the drain, and tile-over-greenboard showers wick moisture until the studs behind them rot. Rebuilds in those homes almost always uncover a drain that needs re-sloping and some rotted framing at the curb. Lakefront properties on the Ray Hubbard shoreline bring a different wrinkle: foundation movement tied to the blackland clay that swells and shrinks near the lake, so tile walls and pans need a little more flexibility built into the waterproofing system.
Permitting is handled through the City of Rowlett for a shower remodel in the same spot; Rowlett’s 75088 and 75089 ZIPs are our most frequent job sites. If a job shifts the drain or adds electrical, we pull the permit and schedule the inspection so it doesn’t stall the tile crew. Rowlett HOAs, especially in the newer lakefront subdivisions, sometimes require glass and tile finish approvals before work starts, and we build that into the schedule. Homeowners often pair a shower upgrade with Roof Replacement & Installation in Rowlett after the spring hail season, or with Metal Roofing in Rowlett on the lakefront rebuilds where wind-driven rain is a constant concern. All of it falls under our service in Rowlett, so one contractor can coordinate the sequence.
Serving Rowlett, TX – Our Local Coverage Area
We serve Rowlett and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Walk-In Showers & Shower Remodeling in Rowlett

A standard shower remodel takes 5 to 10 working days on site. The longest stage is waterproofing and tile cure time, and a custom pan or large-format tile pushes the top of that range. Call (888) 426-8078 for a schedule specific to your shower.
Yes, most shower remodels in Rowlett require a permit, and any job that relocates a drain, valve, or electrical fixture requires an inspection. We pull the permit and coordinate the inspection as part of the job.
Yes. The majority of Rowlett shower remodels we do keep the shower in the same footprint, which keeps cost and permits simpler. Moving the drain or adding a curbless pan is where the extra cost and time come in.
Frameless glass typically adds $800 – $2,000 depending on size and hardware, and it’s templated after the tile is installed so the fit is exact. Call (888) 426-8078 for a quote that includes glass in the line items.
Every shower we install carries the 730-Day Done Right Promise: if the workmanship isn’t right, we make it right. Tile and fixture manufacturer warranties apply on top of that. Call for the full warranty terms before work starts.
Get a Free Walk-In Showers & Shower Remodeling Estimate in Rowlett
Call (888) 426-8078 to schedule a free on-site estimate in Rowlett. We’ll measure the shower, photograph the rough-in, and hand you a written line-item quote with pan, tile, fixtures, glass, and labor broken out. No-hassle upfront pricing, a background-checked uniformed technician on the visit, and a live person on the phone 24/7. Our technicians have up to 12 years of experience, and the 730-Day Done Right Promise backs every install.
Written by the team at Groundwork Construction Co..












