







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wood Fence in Garland, TX: What It Costs and How Long It Takes
A wood fence in Garland, TX typically runs $3500 – $9000 for a standard residential lot, and most jobs are built in 2 – 3 working days once materials land on site. That price covers cedar or treated pine privacy runs, posts set in concrete, and a gate or two. Wind matters here more than in most Texas cities, so we build to a wind-load spec rather than eyeballing post depth. Call (888) 426-8078 for a free on-site estimate.
How We Build a Wood Fence in Garland, Start to Finish

Every wood fence job follows the same five stages. The number of days we spend on each depends on run length, terrain, and how much old fence has to come out. Here’s what actually happens.
Stage 1: On-site measure and layout (day 1, about 90 minutes)
We walk the property line with you, measure the full run, and flag anything underground: irrigation lines, gas stubs, low-voltage lighting, or an old footing from a previous fence. You decide the fence height, gate placement, and which side faces the neighbor. We mark post locations in spray paint so nothing gets dug before you’ve signed off.
Stage 2: Demolition and post setting (day 1, 3 – 5 hours)
If there’s an existing fence, we pull it, haul it off, and reset any posts that won’t hold. New posts go in at 6 to 8 feet on center, set in concrete and cured overnight. Wind-rated builds use deeper footings and thicker posts. On Garland’s clay, that footing depth matters: expanding and contracting soil will heave a shallow post out within a couple of seasons.
Stage 3: Rails, pickets, and framing (day 2, 6 – 8 hours)
We set the top and bottom rails, then hang pickets. This is when you see the fence take shape and when the last material decisions get locked in: board width, spacing, cap rail or not. Pickets get nailed or screwed to rails with fasteners rated for treated lumber; cheap galvanized nails will streak and rust, and we don’t use them.
Stage 4: Gates and hardware (day 2 or 3, 2 – 4 hours)
Gates get braced frames, heavy-duty hinges, and a latch, plus a drop rod on wider openings. A poorly hung gate is the number one thing that fails within a year, so we hang it last, once everything else is square, and check the swing before we call it done.
Stage 5: Walkthrough and touch-up (day 3, under an hour)
We walk the full run with you, check plumb and height, adjust any gate that sticks, and clean up debris. You get the 730-Day Done Right Promise on the workmanship, and our number stays live if something needs adjusting later.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for a Wood Fence
- Cedar vs. treated pine. Cedar naturally resists rot and insects and holds stain better; it costs more per linear foot. Treated pine is the budget-friendlier workhorse and does fine in North Texas if it’s properly sealed. On a full perimeter, the gap between the two can be a couple thousand dollars.
- Privacy height. Six feet is the Garland standard for residential property lines. Eight feet gives more screening but triggers more wind load and needs thicker posts and deeper footings to hold up in a spring storm.
- Board-on-board vs. dog-ear pickets. Board-on-board overlaps boards for full privacy and a cleaner look at a modest cost premium. Dog-ear pickets are the common, cheaper choice.
- Post spacing. Standard 8-foot centers work in calm areas. Wind-rated builds call for 6-foot centers and deeper concrete footings, which adds cost but keeps the fence standing through a North Texas gust event.
- Stain and seal. Untreated pine will gray out within a year here. A quality stain or sealer adds a small line item and buys you years of life.
- Gates and access. A driveway gate or side gate is priced separately from the linear run; wider openings need heavier hardware.
Homeowners planning a bigger outdoor project often pair a new fence with Paver Driveways in Garland so the front and back of the property get finished at the same time.
See the difference
Before
After
Before
After
Before
AfterWhat a Wood Fence Costs in Garland, TX

Plan on $3500 – $9000 for a wood fence in Garland, with the typical single-family job landing near the middle. Five things move that number most:
- Linear footage. A standard lot perimeter sits around 150 – 200 feet. Longer runs scale the cost directly.
- Fence height and posts. An 8-foot privacy run costs meaningfully more than a 6-foot one, because it needs heavier posts and deeper footings for wind load.
- Material grade. Cedar at the high end, treated pine at the low end.
- Demo and haul-away. Tearing out an old fence and disposing of it is a real line item.
- Site conditions. Sloped yards, tight lots, and rocky or root-heavy digging add labor.
A written estimate from us lists fence footage, post count, material grade, stain, gates, and haul-away as separate lines. Upfront pricing, no surprises: the number on the contract is the number you pay.
What Garland Homes Specifically Do to This Job
Garland is a post-war streetcar suburb grown into a full city, and the building stock splits sharply along a construction-era line. In the older core around 75040, 75041, and 75042 near downtown, you’ll find 1950s and 60s single-story brick ranches with tight side yards and lots that have already cycled through two or three fences. Out toward 75043 and 75044, the 1970s-90s subdivisions and newer homes come with larger backyards and different post-depth expectations. That gap is the real local expertise: knowing which era of lot you’re standing on before we bid.
The clay soil here expands and contracts hard between wet springs and dry summers, which is why post footings that look fine in July can heave loose by the next wet season. We set them deeper on the older lots where the fill has settled unevenly. Hail and high wind events are routine, so a failing fence line gets noticed fast. And Garland runs its own permitting and inspections rather than deferring to the county, so a fence over the standard residential height can require review. We handle that paperwork and confirm the setback and HOA rules for your block before a single post gets dug. We also cover the surrounding towns like Garland and the adjacent communities, so scheduling is built around your ZIP.
Serving Garland, TX – Our Local Coverage Area
We serve Garland and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Wood Fence in Garland

A standard residential wood fence in Garland takes 2 – 3 working days once materials arrive. Weather, run length, and old-fence demo can push it. Call (888) 426-8078 and we’ll give an exact window on your lot.
Garland residential fence height is typically limited to 6 feet without a review, and anything taller or along certain property lines may require a permit. We check your specific zoning and HOA rules as part of the estimate, then pull any permit needed and handle the inspection.
Yes, in the vast majority of cases. We call in locates for underground utilities before digging, and post lines get shifted a few inches where needed to clear irrigation or gas lines. If something sits directly in the fence line, we flag it and adjust the layout before we start.
Most Garland wood fence jobs land between $3500 and $9000, depending on footage, grade, and height. Call (888) 426-8078 for an exact figure on your property, with a free on-site estimate and a written line-item quote.
Our workmanship is backed by the 730-Day Done Right Promise; if a post heaves, a gate sags, or a run isn’t square, we make it right. Material warranties come from the lumber supplier and vary by grade.
If you want a wood fence rebuilt to stand through Garland’s wind and clay, or you’re wrapping it into a full Fence Installation in Garland project, our Fence Installation team can also pair it with Concrete Driveways & Concrete Work in Garland. Call (888) 426-8078 for a free estimate and design consult; a live person answers 24/7.
Written by the team at Groundwork Construction Co.












