







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Garland, TX: What the Job Actually Involves
Door installation in Garland, TX typically runs $650 to $3,200 per opening including the slab or prehung unit, trim, hardware and labor, and most single exterior doors are finished in one day. Interior doors usually land between $350 and $900 each. The number that matters depends on whether you’re swapping a door into an existing frame or rebuilding the rough opening – and on Garland’s acreage properties with detached workshops, oversized doors and heavy gates, we plan for heavier hardware and a full-day trip rather than a quick return visit. Call (888) 426-8078 and we’ll set up a free on-site estimate.
How We Run a Door Installation in Garland, Start to Finish

Every door job follows the same five stages. What changes is how long each one takes and what you’ll need to decide along the way. Here’s the honest sequence.
Stage 1: Measure and inspect (day 1, about 45 minutes)
We measure the rough opening, check the frame for rot, square and plumb, and photograph the existing threshold and flashing. On Garland acreage properties we also check the door’s exposure – a workshop door facing an open field takes wind-driven rain that a covered front entry never sees. You’ll get a written line-item estimate before anything is ordered, and nothing gets cut until you approve it.
Stage 2: Order and confirm specs (day 2 to day 10, depending on the unit)
Stock sizes in standard finishes ship in a few days. Custom-width doors, non-standard colors and impact-rated units take longer. This is where you decide material, glass package, handing (left or right swing) and hardware finish. We confirm the order in writing so there’s no surprise on delivery day.
Stage 3: Prep and demo (day of install, 1 to 2 hours)
We pull the old door and trim, inspect the framing for water damage and pest issues, and repair or sister any soft studs before the new unit goes in. On older Garland ranches, this step regularly adds time because a 1960s sill has been quietly absorbing moisture for decades. Better to find it now than after the trim goes back on.
Stage 4: Set, shim and seal (day of install, 2 to 3 hours)
The new door gets shimmed plumb, anchored, insulated at the gap and flashed at the head and sill. We test the swing, set the strike plate and confirm the latch catches cleanly. On heavier workshop or oversized doors we mount heavier-duty hinges and hardware rated for the weight, so the door doesn’t sag six months in.
Stage 5: Trim, finish and walkthrough (day of install, 1 to 2 hours)
Casing and trim go back on, caulk lines get sealed and the door gets a function test with you standing there. We hand over the warranty paperwork and walk the opening together before we pack up. Most single-door jobs are done in a day; multi-door projects on larger Garland properties sometimes need a second visit for paint and final trim.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for Door Installation
The door itself drives about half the total cost. Here’s what actually matters when you’re picking one.
- Steel vs. fiberglass exterior doors: Steel runs $400 to $1,200 installed and takes paint well, but it dents and can rust at the bottom edge in Garland’s humid summers. Fiberglass at $800 to $2,500 holds up better against hail and heat and won’t dent – the trade-off is higher cost and a factory finish you can’t easily touch up.
- Wood doors: Beautiful, warm and repairable, but they need refinishing every few years on a west-facing wall. Budget $1,000 to $3,000 installed, plus maintenance.
- Prehung vs. slab replacement: A prehung unit (frame and door together) is faster and more reliable but costs more. A slab swap into a healthy existing frame saves $150 to $400 per door if the frame is square and sound.
- Glass and impact ratings: Decorative glass adds $200 to $800 per door. In Garland’s hail corridor, impact-rated glass and impact-rated doors are a routine upgrade, not an exotic one – and they can lower insurance premiums.
- Hardware grade: Standard builder-grade locksets fail faster on high-traffic exterior doors. Upgrading to a commercial-grade hinge and deadbolt package is a $100 to $250 add that pays back in fewer adjustments.
- Sliding barn and workshop doors: Common on acreage properties with outbuildings. These need a heavier track system and header blocking, which we plan for during the measure.
What Door Installation Costs in Garland, TX

Plan on $650 to $3,200 for a standard exterior door installed, and $350 to $900 for an interior door. Oversized, custom or impact-rated units push toward the high end; a straightforward interior swap sits at the bottom.
Four things move the number:
- Opening condition: A clean existing frame keeps you at the low end. Rotted sill plates, out-of-square framing or pest damage can add $200 to $800 in prep and repair.
- Unit size and weight: Standard 36-inch doors are cheapest. Oversized workshop doors and wide double doors require heavier hardware, more blocking and sometimes a header modification.
- Material grade: Builder-grade steel versus premium fiberglass or wood swings the total by $600 to $1,800 per door.
- Permit scope: A like-for-like swap usually doesn’t require a permit. Structural changes to the rough opening or a new opening in an exterior wall will.
Our written estimate lists the unit, hardware, trim, labor, disposal and any repair allowance as separate lines so you can see exactly where the money goes. What typically isn’t included: painting or staining beyond a basic touch-up, and structural framing if we discover something concealed during demo – though we price that change before we proceed, never after.
See the difference
Before
After
Before
After
Before
AfterWhat Garland Homes Specifically Do to This Job
Garland’s building stock splits along an era line, and that line changes how a door job goes. The older core in 75040, 75041 and 75042 – post-war ranches near the old downtown – often has original 1950s and 60s door frames with single-pane glass and worn thresholds. We regularly find sill rot, out-of-square openings and undersized electrical service nearby that becomes a hidden cost on a job that looked simple from the curb. Out toward 75044 and 75043, the 1970s to 90s subdivisions have their own quirks: wider frames, sometimes aluminum-clad units, and slab-on-clay foundations that shift enough to throw a door out of plumb as the Blackland Prairie clay swells and contracts between wet springs and dry summers.
Garland runs its own permitting and inspections rather than deferring to the county, so a structural change gets documented and inspected – which protects you at resale. And on the acreage properties with detached workshops, we plan the service trip to cover every opening at once, because nobody wants a second visit three weeks later. If your project expands into more than doors, it’s worth looking at the wider scope on our Windows & Doors in Garland page. Homeowners often pair exterior door replacement with Chain Link Fence in Garland for outbuildings and property lines, or Vinyl Fence in Garland for a cleaner front-yard look.
Serving Garland, TX – Our Local Coverage Area
We serve Garland and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Garland

A single exterior or interior door is typically installed in one day, usually four to six hours from demo to walkthrough. Multi-door projects on larger Garland properties may need a second visit for paint and trim. Call (888) 426-8078 for a firm timeline on your specific opening count.
A like-for-like swap into an existing frame generally doesn’t require a permit. Any change to the rough opening size or a new opening in an exterior wall does, and it gets inspected. We’ll tell you up front which category your job falls into. Call (888) 426-8078 for a free estimate.
Yes – in most cases a door swap is a straight opening job with no plumbing or structural work. The exception is a door that’s been framed out of square by foundation movement, which we assess during the measure. Call (888) 426-8078 to schedule the on-site check.
Exterior doors run $650 to $3,200 installed and interior doors $350 to $900 each. The range is driven by material grade, opening condition and whether the unit is oversized. Call (888) 426-8078 for an exact quote – estimates are free.
All of our door installation work is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. Manufacturer warranties on the unit itself run alongside it. Call (888) 426-8078 to talk through the details.
Get a Free Door Installation Estimate in Garland
Doors on an older Garland ranch, a workshop on acreage, or a full exterior replacement across several openings – we’ll come measure, show you the options and leave you with a written line-item estimate the same visit. No-hassle upfront pricing, no surprises, and workmanship backed by our 730-Day Done Right Promise. Call (888) 426-8078 and a live person answers, day or night, to set up your free estimate.
Written by the team at Groundwork Construction Co..












